53--Fastener Set, Balanc (Please refer to the Description/Synopsis and/or Place of Performance for POC on this effort)

****ATTENTION****ALL FORMAL COMMUNICATION RELATED TO THIS ACQUISITION MUST BE DIRECTED TO: Deana McKay, Contract Specialist; email: contact@example.gov. No telephone calls will be accepted. PRON: AX4CF410AX; NOUN: Fastener Set, Balanc; NSN: 5325-01-541-1768; P/N: 075528-1452; qty of 6 each on a One time buy type contract with deliveries to New Cumberland, PA. Required delivery is 6 each until contract completion. This requirement is restricted to Ameridrives International, LLC. (CAGE: 70487) because this part is a commercial/non-developmental/off the shelf item. As such, it is now governed by the Federal Aviation Administration (FAA) rules. Only FAA qualified sources are listed. Other prospective sources must qualify through the FAA under the Part Manufacturer Approval (PMA). Adequate technical data is not available for this acquisition. All offerors must meet prequalification requirements in order to be eligible for award. All prospective manufacturers, or distributors, seeking to compete for a solicitation for Aviation and Missile Life Cycle Management Command (AMCOM) Spares, for any restricted source parts, are required to be an AMCOM approved source. To obtain approval, vendors must submit a SAR package, for review and approval, to the Engineering Directorate (ED), Quality Engineering Division. Source approval must be obtained prior to being considered for contract award. Approvals are made on an individual part number basis for a specific manufacturing location (CAGE). Firms are encouraged to seek source approval in order to compete for future solicitations by following the SAR submission guidance provided on the website: http://amcomdmz.redstone.army.mil/casl_cmo/casldba.casl_cmo_samsar. Questions concerning SAR submissions can be directed to the ED SAR Team at contact@example.gov or call the SAR Team at +1 (555) 000-0000, +1 (555) 000-0000 or +1 (555) 000-0000. The closing date annotated is an estimated date and may be adjusted dependent upon the date of release of solicitation however; solicitation will not close prior to the closing date stated above. Foreign firms are reminded that all requests for solicitation must be processed through their respective embassies.