Air Compressor System and Lean-to-Shelter

This solicitation, FA301626Q0144, is a Request for Quotation issued under FAR Part 12 for the procurement of a commercial air compressor system and a lean-to-shelter, solely set aside for small business concerns under NAICS Code 333912. The award will be made on a Lowest Priced, Technically Acceptable basis, requiring quotes to include full technical details such as manufacturer, make, model, and product literature to demonstrate compliance with the Statement of Work. The air compressor system must include a 30 HP electric rotary compressor compatible with 208v power, a two-stage filtration system rated at 123 CFM, a minimum 660-gallon vertical tank operating at 200 psi, a pneumatic no-loss drain kit, an electronic controller, ducting to direct exhaust away from the roof, and features for automatic restart after power outages and programmable eco-mode operation. All components must be new and unused, with installation requiring brass ball valves, piping to connect to the existing airline without anchoring to Building 245’s exterior wall, and the ability to isolate the new system from shared infrastructure. The lean-to-shelter is a separate deliverable, both items due by August 31, 2026, under FOB Destination terms at JBSA-Randolph, Texas. Site visit is scheduled for June 24, 2026, and quotes must be submitted no later than July 8, 2026, at 4:00 p.m. CDT, following an amendment that extended the original deadline from July 1. All offers must comply with stringent federal contracting provisions including FAR 52.212-4, with tailored language restricting contract modifications to written agreement, and mandatory clauses such as 52.204-13 and 52.209-10 under deviation 2026-O0038. Contractors must be actively registered in SAM and certify compliance with Buy American, Defense Information Safeguarding, and prohibitions concerning inverted domestic corporations, Maduro regime dealings, and Xinjiang Uyghur Autonomous Region sourcing. Unique Item Identification per MIL-STD-130 and shipment labeling per MIL-STD-129 are required for all deliverables, with verification using automatic identification technology and reporting of UIDs in the Material Inspection and Receiving Report via