Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, September 16 at 2:00 PM EDT

Register Free →

This Solicitation opportunity from National Aeronautics And Space Administration was posted on May 5, 2026. The submission period has ended. Browse the details below for market research, or find similar active opportunities.

Benchtop Network Analyzer, ZNLE6, is required for signal and power integrity analysis

Closed
80NSSC26932460QFederal

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

Active Opportunities Like This One

AI Contract Overview

Show more

NASA/NSSC is proceeding with a sole source procurement under FAR 12.102(a) to acquire a Benchtop Network Analyzer, model ZNLE6, from Rohde & Schwarz USA, Inc., as the exclusive provider of this equipment for signal and power integrity analysis critical to avionics testing at Wallops Flight Facility. The procurement is structured as an 8(a) sole source set-aside, indicating the vendor is a certified small business participating in the SBA’s 8(a) Business Development Program, and the acquisition will follow streamlined commercial item procedures outlined in FAR Part 12. The technical requirements specify a device with a frequency range extending from 100 kHz to 6 GHz, a dynamic range of at least 110 dB, a noise floor no higher than -120 dBm, two test ports, time-domain analysis with distance-to-fault capability, Ethernet and USB 3.0/C interfaces, and physical dimensions not exceeding 16.5 inches wide, 7.5 inches high, and 9.5 inches deep, weighing less than 13.5 pounds. Delivery must occur within five weeks of contract acceptance, with no specified FOB terms or place of delivery beyond the performance location at NASA/WFF. The solicitation does not include pricing details, contract type (e.g., FFP), or evaluation factors due to its non-competitive nature, and no formal inspection criteria or packaging standards are defined beyond implied conformance to commercial item norms under FAR Part 12. Responses to this notice, limited to written submissions of capabilities and qualifications, are due by 3:00 p.m. Central Standard Time on May 7, 2026, and must be emailed to McKenzie Hanson, Procurement Specialist at NASA/NSSC. The NASA FAR Supplement Clause 1852.215-84, Ombudsman, applies to facilitate communication, and the NAICS code for this acquisition is 334515. No payment office, accounting codes, COR/COTR details, or formal attachments are provided, and the solicitation number is 80NSSC26932460Q.

General Info

NASA sole source contract with ROHDE & SCHWARZ for Benchtop Network Analyzer ZNLE6.

Agency

National Aeronautics And Space Administration → NASA Shared Services CenterView Agency

NAICS

334515 - Instrument Manufacturing for Measuring and Testing Electricity and Electrical SignalsView NAICS

Place of Performance

MS, USA

Set-Aside

8A

Documents

(1)

SATPC0041072+Tab+04+4+SOW.pdf

PDF

AI Contract Breakdown

Uniform Contract Format

Sign up to view the full breakdown with detailed analysis of each section.

Timeline

PhaseClosed
Posted

Solicitation

Response Deadline

Deadline has passed

Submission Closed

Find active opportunities like this

Start your free trial to discover similar active contracts, track opportunities, and build proposals with AI assistance.

Organization & Contact Information

Show more
AgencyNational Aeronautics And Space Administration → NASA Shared Services Center
Contacts1 person available
OfficeSTENNIS SPACE CENTER, MS, 39529, USA
Organization / Agency
National Aeronautics And Space Administration → NASA Shared Services Center
View Agency Profile
Office AddressSTENNIS SPACE CENTER, MS, 39529, USA
Contacts
McKenzie Hanson

Full Description

Show more

Synopsis:



NASA/NSSC has a requirement for Benchtop Network Analyzer, ZNLE6, is required for signal and power integrity analysis. 


NASA/NSSC intends to issue a sole source contract to ROHDE & SCHWARZ USA, INC under the authority of FAR 12.102(a). It has been determined that ROHDE & SCHWARZ USA, INC is the sole provider of Benchtop Network Analyzer, ZNLE6, is required for signal and power integrity analysis.


NASA/NSSC will be the procuring center for this effort. Performance will be located at NASA/ WFF.


The Government intends to acquire Commercial items or services using the provisions, clauses and procedures prescribed in FAR Part 12 for Commercial.



The NAICS Code for this procurement is 334515.



Interested organizations may submit their capabilities and qualifications to perform the effort in writing to the identified point of contact not later than 3:00 p.m. Central Standard Time on 5/7/2026. Such capabilities/qualifications will be evaluated solely for the purpose of determining whether or not to conduct this procurement on a competitive basis. A determination by the Government not to compete this proposed effort on a full and open competition basis, based upon responses to this notice, is solely within the discretion of the government.



Oral communications are not acceptable in response to this notice.



NASA FAR Supplement Clause 1852.215-84, Ombudsman, is applicable. The Center Ombudsman for this acquisition can be found at https://www.hq.nasa.gov/office/procurement/regs/Procurement-Ombuds-Comp-Advocate-Listing.pdf .



Primary Point of Contact:


McKenzie Hanson


Procurement Specialist


McKenzie.M.Hanson@nasa.gov

More opportunities from National Aeronautics And Space Administration → NASA Shared Services Center

Same awarding agency

NAICS: 333998
New
Federal
Lower Wing / Elevon Heater Carriages
Solicitation # 80NSSC26937774Q-1
NASA Shared Services Center is soliciting quotes under solicitation 80NSSC26937774Q for the fabrication and delivery of Lower Wing and Elevon Heater Carriage test hardware for the NASA Armstrong Flight Research Center. This firm-fixed-price contract is set aside for small businesses under NAICS code 333998. The scope involves the production of various components, including heater frames, adapter plates, bearing brackets, and axis rods, all of which must be fabricated according to government-furnished design drawings. The target delivery schedule is within 12 weeks of contract award, with a preference for earlier completion. Deliveries are FOB Destination to Edwards, California, and the contractor is required to provide status updates every three weeks. Award will be based on the best value, evaluating price, fabrication duration, technical acceptability, and past performance, with a requirement for three references from the last three years. The contractor must provide a manufacturing process plan and perform dimensional tolerance inspections. Due to the nature of the hardware, strict compliance with U.S. export control laws, including ITAR and EAR, is mandatory. Additionally, the contractor must be registered in the System for Award Management and provide a Cage Code or Unique Entity ID. All contractual inquiries are directed to Tracy Bremer.
All Other Miscellaneous General Purpose Machinery Manufacturing

POSTED

2 days ago

DEADLINE

in 4 days
View Details
NAICS: 811210
New
Federal
2026 Service contract for D8 Discover DaVinci
Solicitation # 80NSSC26942313Q
The NASA Shared Services Center is seeking a service contract for the maintenance of the D8 Discover DaVinci XRD instrument located at the NASA Glenn Research Center. The requirement covers the period of performance from September 10, 2026, to September 9, 2027. Under the authority of FAR 12.102(a), NASA intends to issue a sole source contract to Bruker AXS LLC, as they have been determined to be the sole provider capable of performing these services. The procurement falls under NAICS code 811210 and follows the procedures prescribed in FAR Part 12 for commercial items and services. The scope of work includes both emergency and scheduled maintenance to preserve the original equipment performance of the instrument. All services must be performed by factory-trained service engineers and conducted according to manufacturer instructions, including the verification of radiation safety. The contract provides for unlimited emergency service visits and technical phone support during regular business hours, with a required emergency response time of 48 hours for breakdowns that render the instrument inoperable. While this notice allows interested organizations to submit capabilities and qualifications by September 15, 2026, to determine if the procurement should be competitive, the government explicitly states that price quotes submitted in response to this notice will not be reviewed or accepted.
Electronic and Precision Equipment Repair and Maintenance

POSTED

2 days ago

DEADLINE

in 3 days
View Details

Find Active Opportunities Like This

Get AI-powered intelligence on the opportunities still open

Every page of the solicitation package shredded into a compliance breakdown

AI-powered matching based on your capabilities and past performance

Competitor and incumbent history on the requirement

Automated alerts on amendments, Q&A deadlines, and award

Miguel
Hillary
Keith Deutsch
Christine

Join 650+ contractors already using CLEATUS