12--GA-NWR LE DIV ZONE OFCR-BULLET TRAPS Z-8

The U.S. Fish and Wildlife Service, under the Department of the Interior and administered by FWS SAT Team 3 in Falls Church, VA, is soliciting proposals for the provision and installation of seven Goliath 4X4 Bullet Trap systems along with associated components including stands and lifting lugs, for use at a National Wildlife Refuge Law Enforcement site in Immokalee, Florida. The contract is a firm-fixed-price, small business set-aside under NAICS code 332999 with a performance period from August 24, 2026, to December 31, 2026, and follows commercial item procedures under FAR Part 12. The solicitation requires delivery FOB destination, with inspections and acceptance occurring at the delivery site, and mandates electronic invoicing through the Department of the Treasury’s Invoice Processing Platform. Proposals must be submitted by August 12, 2026, via email to the primary point of contact, and must include a completed SF 1449 form, detailed technical approach narrative, past performance references from at least three similar federal, state, or local government projects, and full pricing information. All offerors must be active in SAM.gov with a valid UEI and self-certify as a small business, with eligibility for WOSB, EDWOSB, or 8(a) status encouraged but not required for submission. Evaluation prioritizes technical experience, capacity, and past performance significantly over price, with no use of lowest price technically acceptable methodology; instead, award will be made based on a trade-off analysis to determine the most advantageous offer. The contractor must identify key personnel and disclose any subcontractors, adhere to strict cybersecurity and identity verification protocols, comply with federal ethics and political activity restrictions, avoid prohibited internal confidentiality agreements, and refrain from discriminatory diversity, equity, and inclusion practices as mandated by deviation clauses. Special packaging and preservation requirements are referenced but not fully detailed, with marking and labeling tied to delivery and shipment identification per standard form instructions. All contract clauses are incorporated by standard FAR templates with one alternate version applied to subcontractor sales restrictions, and no MIL-STD packaging or labeling standards are cited, consistent with commercial item acquisition rules.