JTE - Transmitter, Radar

This contract solicits two units of NSN 5840-01-659-3010, identified as a Radar Transmitter, under solicitation number SPRHA5-26-R-0651 issued by the Department of Defense through the DLA Aviation office at Hill Air Force Base, Utah. The solicitation is structured as a sealed bid with an implicit firm-fixed-price contract type, responding to a Lowest Price Technically Acceptable (LPTA) evaluation framework where price is the dominant factor in award selection, with all non-cost factors deemed significantly less important. Delivery is required to Barstow, California, with F.O.B. Origin terms holding the contractor responsible for packaging and initial transportation setup, while risk transfers at the point of origin. Performance is tied to stringent military standards including MIL-STD-2073-1 for packaging, MIL-STD-129R for marking, and compliance with hazardous materials regulations under DOT, IATA, ICAO, and IMDG codes. ESD-sensitive components must adhere to ANSI/ESD S20.20 and MIL-HDBK-773. Essential documentation includes a Counterfeit Prevention Plan, Engineering Data List, Statement of Work, and Special Packaging Instructions, with mandatory use of the Wide Area WorkFlow system for electronic invoicing. The contract mandates adherence to Buy American provisions, Veterans’ reporting, biobased and recovered material certifications, and supply chain security disclosures per the Federal Acquisition Supply Chain Security Act. Contractors must provide UEI and CAGE codes, declare size status under the 1,350-employee NAICS 334511 standard, and disclose any use or provision of covered telecommunications equipment as defined by FAR and DFARS cybersecurity clauses. Inspection and acceptance are the government’s sole responsibility, to occur at either origin or destination as specified per line item, with compliance verified against a comprehensive set of military and federal standards. All proposals must be submitted electronically or by hard copy to Hill Air Force Base by June 22, 2026, with only MS Office or PDF formats accepted, and must include full representations regarding socioeconomic status, entity identification, and regulatory compliance.