NUT, SELF-LOCKING, HE

NUT,SELF-LOCKING,HE
NUT,SELF-LOCKING,HE
RQ017: PHYSICAL IDENTIFICATION/BARE ITEM MARKING
RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT:
http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx
FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS.
RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES
THE ITEM DESCRIBED IN THIS SOLICITATION
IS DEFINED IN WHOLE OR IN PART BY ARMY
DRAWING(S). THESE DRAWING(S) MAY CONTAIN
A PAINT FINISHING REQUIREMENT. WHERE SUCH
REQUIREMENTS ARE SPECIFIED, USE DCSC DRAWING
16236 CS-2300-0001 IN LIEU OF FINISH REQUIRE
MENTS OF THE ARMY DRAWING(S). THIS DRAWING
CONTAINS SPECIFICATIONS FOR CHEMICAL AGENT
RESISTANT COATINGS (CARC), AND ADDITIONAL
INFORMATION RELATING TO HIGH TEMPERATURE
COATINGS.
DCSC DWG IS AVAILABE AT DISC.
THE DRAWING(S) LISTED BELOW ARE AVAILABLE AT
DLA DURING "OPEN SOLICITATION ONLY".
TO RECEIVE A COPY OF THE DRAWING(S)<(>,<)>
FOR EBS SOLICITATIONS USE URL
HTTPS://WWW.DIBBS.BSM.DLA.MIL/RFQ/
SAMPLING:
THE SAMPLING METHOD SHALL BE IN ACCORDANCE WITH MIL-STD-1916 OR ASQ
H1331, TABLE 1 OR A COMPARABLE ZERO BASED SAMPLING PLAN UNLESS OTHERWISE
SPECIFIED BY THE CONTRACT. IF THE APPLICABLE DRAWING, SPECIFICATION,
STANDARD, OR QUALITY ASSURANCE PROVISION (QAP) SPECIFIES CRITICAL, MAJOR
AND/OR MINOR ATTRIBUTES, THEY SHALL BE ASSIGNED VERIFICAITON LEVELS OF
VII, IV AND II OR AQLS OF 0.1, 1.0 AND 4.0 RESPECTIVELY. UNSPECIFIED
ATTRIBUTES SHALL BE CONSIDERED AS MAJOR UNLESS SAMPLING PLANS ARE
SPECIFIED IN APPLICABLE DOCUMENTS. FOR MIL-STD-1916, THE MANUFACTURER
MAY USE THE ATTRIBUTE OR VARIABLE INSPECTION METHOD AT THEIR OPTION OR
PER THE CONTRACT. MIL-STD-105/ASQ Z1.4 MAY BE USED TO SET SAMPLE LOT
SIZE, BUT ACCEPTANCE WOULD BE ZERO NON-CONFORMANCES IN THE SAMPLE LOT
UNLESS OTHERWISE SPECIFIED IN THE CONTRACT.
MERCURY OR MERCURY CONTAINING COMPOUNDS SHALL
NOT BE INTENTIONALLY ADDED TO<(>,<)> OR COME IN DIRECT
CONTACT WITH<(>,<)> ANY HARDWARE OR SUPPLIES FURNISHED
UNDER THIS CONTRACT. EXCEPTION: FUNCTIONAL MERCURY
USED IN BATTERIES, FLUORESCENT LIGHTS, REQUIRED
SPE4A6-27-T-3806
SECTION B
INSTRUMENTS; SENSORS OR CONTROLS; WEAPON SYSTEMS;
AND CHEMICAL ANALYSIS REAGENTS SPECIFIED BY NAVSEA.
PORTABLE FLUORESCENT LAMPS AND PORTABLE INSTRUMENTS
CONTAINING MERCURY SHALL BE SHOCK PROOF AND CONTAIN
A SECOND BOUNDARY OF CONTAINMENT OF THE MERCURY OR
MERCURY COMPOUND. (IAW NAVSEA 5100-003D).
NO ASBESTOS AS DEFINED IN FED-STD-313 IS
PERMITTED IN THIS ITEM
THIS NSN HAS QUALIFIED PRODUCTS LIST (QPL)
REQUIREMENTS.
THE (QPL) DOCUMENT IS PUBLISHED AND MAINTAINED
BY THE PERFORMANCE REVIEW INSTITUTE,
161 THRON HILL ROAD,WARRENDALE, PENNSYLVANIA
15086-7527. TO VIEW CONTRACTORS CURRENTLY
APPROVED BY (PRI) GO TO http://www.p-r-i.org http://www.p-r-i.org
THE MANUFACTURER FOR THE QPL ITEM MUST BE APPROVED FOR THE QPL ITEM AT THE TIME OF THE CONTRACT AWARD. PRI-SAE QPL APPLIES. THE PRI-SAE QPL CAN BE OBTAINED THROUGH THE PRI-SAE WEB SITE: WWW.PRI.SAE.ORG CLICK ON THE QUALIFIED PRODUCT LIST LINK TO LOCATE THE APPLICABLE QPL. CERTIFICATE OF CONFORMANCE PROCEDURES (FAR 52.246-15) ARE AUTHORIZED, UNLESS WITHELD BY A QUALITY ASSURANCE LETTER OF INSTRUCTION.
RQ009: INSPECTION AND ACCEPTANCE AT ORIGIN
CRITICAL ITEM SOURCE INSPECTION REQUIRED.
RQ001: TAILORED HIGHER LEVEL CONTRACT QUALITY REQUIREMENTS
(MANUFACTURERS AND NON-MANUFACTURERS)
CRITICAL APPLICATION ITEM
TDP Rev A Gen 3 IAW BASIC DRAWING NR 19207 11609727 REVISION NR C DTD 04/26/1988 PART PIECE NUMBER: 11609727-1
TDP Rev A Gen 3 IAW REFERENCE DRAWING NR 19207 11609727-1 REVISION NR 08 DTD 08/10/2026 PART PIECE NUMBER:
DLA issues this document using the DoD authorized unit of issue, please refer to the following URL to determine the corresponding ANSI X12 unit of issue.
https://view.officeapps.live.com/op/view.aspx?src=https%3A%2F%2Fwww.dla.mil%2FPortals%2F104%2FDocuments% 2FDLMS%2FeApplications%2FLogDataAdmin%2FUnitofIssueandPurchaseUnit.xlsx&wdOrigin=BROWSELINK
CLIN PR PRLI UI QUANTITY UNIT PRICE TOTAL PRICE.
0001 7017744534 0001 EA 5.000
NSN/MATERIAL:5310001394627
DELIVERY (IN DAYS):0020
DELIVER FOB: ORIGIN
SPE4A6-27-T-3806
SECTION B
PR: 7017744534 PRLI: 0001 CONT’D
QTY VARIANCE: PLUS 0% MINUS 0%
INSPECTION POINT: ORIGIN
ACCEPTANCE POINT: ORIGIN
PREP FOR DELIVERY:
PKGING DATA MIL-STD-2073-1E
QUP:001 PRES MTHD:31 CLNG/DRY:1 PRESV MAT:00
WRAP MAT:00 CUSH/DUNN MAT:00 CUSH/DUNN THKNESS:0
UNIT CONT:BL OPI:M
INTRMDTE CONT:BL INTRMDTE CONT QTY:AAA
PACK CODE:U
MARKING SHALL BE IN ACCORDANCE WITH MIL-STD-129.
SPECIAL MARKING CODE:00 -00 No special marking
PALLETIZATION SHALL BE IN ACCORDANCE WITH RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
IP056: MERCURY OR MERCURY COMPOUNDS ARE PROHIBITED IN PRESERVATION,
PACKAGING, PACKING AND MARKING.
BULK BREAK POINT:
W55WNU
W8UN KS ARNG MATES 1
CAMP FUNSTON
BLDG 1460 5TH AND ALPHA STREET
FORT RILEY KS 66442-0345
US
SHIP BY TRACEABLE MEANS. DO NOT USE PARCEL POST.
FREIGHT SHIPPING ADDRESS:
W55WNU
W8UN KS ARNG MATES 1
CAMP FUNSTON
BLDG 1460 5TH AND ALPHA STREET
FORT RILEY KS 66442-0345
US
MARKFOR
W55WNU
W8UN KS ARNG MATES 1
CAMP FUNSTON
BLDG 1460 5TH AND ALPHA STREET
FORT RILEY KS 66442-0345
US
M/F: (TCN) W55WNU62100276
RDD:
PROJ: TP 3
SUPP ADD: W81K4N SIG: A
FOR GOVERNMENT USE ONLY: (IPD) 13
DIC: A3A DIST: ADV: FC: 62
SPE4A6-27-T-3806
SECTION B
PR: 7017744534 PRLI: 0001 CONT’D
Need Ship Date:00/00/0000 Original Required Delivery Date:08/03/2026
SPE4A6-27-T-3806 NSN/Part Number: 5310-00-139-4627 Quantity: 5 EA Purchase Request: 7017744534QTY: 5 Delivery: 20 days ADO