PIN-RIVET

The contract is for the procurement of 6 units of PIN-RIVET with NSN 5320017137774 and approved part number HST10YV8-15 from qualified suppliers including SPS TECHNOLOGIES, LLC and HI-SHEAR CORPORATION. Delivery is required FOB Origin to DLA Distribution Cherry Point in Cherry Point, NC, with a 98-day delivery timeline ending on September 8, 2026, and no variance is permitted in quantity. Inspection and acceptance occur at the destination, governed by FAR 52.246-2 and requiring compliance with MIL-STD-1916, ASQ H1331 Table 1, or an equivalent zero-based sampling plan. Critical, major, and minor attributes are to be verified at levels VII, IV, and II with corresponding AQLs of 0.1, 1.0, and 4.0; unspecified attributes are treated as major. Packaging must conform to MIL-STD-2073-1E and marking to MIL-STD-129 with no special marking required. Palletization follows DLA's RP001 packaging requirements, and hazardous materials must be labeled per 29 CFR 1910.1200. The solicitation incorporates the DLA Master Solicitation for Automated Simplified Acquisitions Revision 105 and mandates adherence to all referenced technical and quality requirements via R and I numbers from the DLA Master List. Additive manufacturing is prohibited unless specifically authorized, and failure to submit a Safety Data Sheet renders an offer ineligible. Contractors must comply with the Buy American Act and Berry Amendment, with a $150,000 threshold, and certify that they will not supply covered telecommunications equipment under DFARS 252.204-7018. Cybersecurity obligations under DFARS 252.204-7012 and NIST SP 800-171 assessment requirements are binding. All quotes must be submitted electronically via DIBBS by August 17, 2026, and payment processing requires electronic submission through WAWF. The contract includes compliance with federal regulations on employment eligibility, trafficking in persons, sustainable products, whistleblower rights, and other labor and safety standards, with deviations applied to several FAR clauses effective February 2026. Contractors must maintain current SAM registrations and