Repair and Replace Individual Storage Units (ISU 90)

INDIVIDUAL STORAGE UNIT (ISU90) WORK COVERED BY CONTRACT: The contractor shall provide all materials engineering, equipment, transportation and supervision necessary to perform the work as described herein. All work shall be conducted per this scope of work and all applicable Federal, State and local laws, regulations, codes and directives. REFERENCES: The publications listed below form a part of the specifications to the extent Referenced. 1. Code of Federal Regulations CFR)29 CFR 1926 Construction Industry Standards. SCOPE OF WORK: Individual Storage Unit DESCRIPTION OF NEW ISU's: 1-CONTAINER ISU 90 GEN X GREEN WITH KIT-165 Part#56102165 Quantity-5 Kit contains (8) Shelf assemblies (2) Divider panels 2-CONTAINER ISU 90 GEN X GREEN WITH KIT- Part#56102TBD Quantity-1 Kit contains (1) 7-Drawer Stanley Vidmar Cabinet, Factory Installed (2) Shelf Assemblies 3-CONTAINER ISU 90EO GEN X GREEN WITH KIT-Part#56121TBD Quantity-1 Kit contains (1) Middle support panel (6) Side Support panels DESCRIPTION OF ISU NEEDS REPAIRING: 001 ISU90 56000 series, Serial #92752, Repair Damage 3" or Less (per GSA SIN 61711) Repair Door Seal (Per GSA SIN 61711); 002 ISU90 56000 series , Serial #92752, Repair Puncture 6x6 (per GSA SIN 61711); 003 ISU90 52000 series, Serial #19876, Repair Hole in bottom of ISU (3" or smaller)(Per GSA SIN 61711); 004 ISU90 54000 series, Serial #19805, Repair Hole in Bottom of ISU (3" or smaller)(Per GSA SIN 61711) Repair GSA SIN 61711) Repair Puncture 6x6 (Per GSA SIN 61711); 005 FRAME MIDDLE SUPPORT ASSSY; 006 Field Install Support Frame Middle (Labor Only); 007 FRAME SIDE SUPPORT ASSY; 008 Field Install Support Frame Side (Labor Only); 009 Remove and re-install existing weapons racks (Labor only); 010 Remove and re-install existing boat motor rack also replaces rollers as needed. SITE VISIT: Contractor is to contact SK2 Sykes and/or LT Frye to arrange time and days for work to be accomplished after receiving notification to proceed. MILITARY REGULATIONS: The contractor, his employees amd sub contractors shall become familiar with and obey all station regulations. All personnel employed on the project shall keep within the limits of the work and the avenues of the egress, and shall no enter any other areas outside the site of work unless authorized by SK2 Sykes or LT Frye. There shall be no smoking in any Coast Guard building and only in designated areas. WORK HOURS: The contractor shall perform all site work during the normal operation hours of 0800-1600 Mon-Fri except during federal holidays. Any deviations from normal working hours will be at the discretion of SK2 Sykes and/or LT Frye. CLEAN UP OF WORK AREA: The contractor shall remove and properly dispose of all trash and debris pertaining to the contract work from the limits of government property, as well as all adjacent affected areas. Disposal shall be in accordance with federal, state and local regulations. ACCEPTANCE OF WORK: Prior to acceptance of work by the Coast Guard, the contractor shall arrange through SK2 Sykes/LT Frye, a review of the estimate to ensure all items have been inspected to identify necessary inspection certificates, tags and to ensure work satisfaction and proper area clean up. COAST GUARD POC INFORMATION: SK2 Herman Sykes (419)635-4462 x 115 Herman.F.Sykes@uscg.milor LT Steven Frye (419)635-4462 x 120 Steven.A. Frye@uscg.mil