REPAIR OF ICT-1500/2500 DETECTION, CONTROL AND MOTION SYSTEMS - Hill Air Force Base, Utah

This notice is issued solely for information and planning purposes - it does not constitute a Request for Quote (RFQ)/Invitation for Bid (IFB)/Request for Proposal (RFP) or a promise to issue an RFQ, IFB or RFP in the future. This notice does not commit the U.S. Government to contract for any supply or service. Further, the U.S. Government is not seeking quotes, bids or proposals at this time and will not accept unsolicited proposals in response to this sources sought notice. The U.S. Government will not pay for any information or administrative costs incurred in response to this notice. Submittals will not be returned to the responder. Not responding to this notice does not preclude participation in any future RFQ or IFB or RFP, if any is issued. If a solicitation is released, it will be synopsized on the Government wide Point of Entry. It is the responsibility of potential offers to monitor the Government wide Point of Entry for additional information pertaining to this requirement. The anticipated NAICS code is: 334517 Irradiation Apparatus Manufacturing. Size Standard: 1,000 employes --- The Industrial Computed Tomography 1500/2500 (ICT-1500/2500) and associated subcomponents located in BLDG 984 is a sophisticated Computed Tomography (CT) inspection system. This system uses computed tomography to inspect solid rocket motors internally for anomalies in a non-destructive manner and are vital to the inspection and sustainment of the Minuteman III (MMIII) Intercontinental Ballistic Missile (ICBM) weapon system. The contractor's responsibilities for the Extension of Life for the ICT 1500/2500 will include replacement of all related part and hardware of the ICT 2500 system to include Linear Diode Array, Scintillator Assembly, Reference Detector, Printed Circuit Boards (PCB's), all included components within the Detector Assembly (power supply, mother boards, analog processor boards, detector modules which house the crystals, analog-to-digital converter, and detector input output boards), Motors and Controls, Motion Controls, External Encoders, Operational Software and Operation/Diagnostic Workstations. All components within the ICT-1500 & ICT-2500 upgrade shall be upgraded to current, modern technology, and standards. This project is combined to maintain uniformity between both ICT-1500 and ICT-2500 systems. This project is to be worked as a 2-year phased project to correspond with the government funding years. Contractor shall perform upgrade on ICT-2500 during FY24.The final project phase will need to be the x-ray source upgrade as lead times are much longer on these kits. 2. Contractor shall perform upgrade to ICT-1500 during FY25. The final project phase will need to be the x-ray source upgrade as lead times are much longer on these kits.