RUBBER SHEET, SOLID

The contract specifies the procurement of solid rubber sheeting meeting MIL-G-1149, Type 1, Class 2 standards, with dimensions ranging from 35.0 to 37.0 inches in width and a thickness between 0.046 and 0.078 inches, with no restrictions on length. The material must be marked with both the cure date and expiration date to ensure compliance with a non-extendable 36-month shelf life as defined by RS020 and RS001 for a Type I (Code Q) item. The rubber sheeting is designated as a critical item requiring source inspection, and it must adhere to MIL-STD-130N for identification marking of U.S. military property. No asbestos is permitted as defined by FED-STD-313. Sampling must follow MIL-STD-1916 or ASQ H1331 Table 1 with zero non-conformances required in the sample lot unless otherwise stated, with critical, major, and minor attributes assigned verification levels VII, IV, and II or AQLs of 0.1, 1.0, and 4.0 respectively. All technical and quality requirements referenced by R or I numbers are incorporated from the DLA Master List of Technical and Quality Requirements, with the applicable revision determined by the solicitation issue date or amendment date. The item, identified by NSN 9320-01-178-9357, is being procured in a quantity of 19 square yards under solicitation SPE8E9-26-T-3130 with a 123-day delivery window. This is a fully competitive federal procurement classified under NAICS code 339991, managed by the Department of Defense’s Construction & Equipment MRO Service I, with deliveries directed to New Cumberland, PA, and primary point of contact being Matthew Kruc at DLA.