SCREW, CAP, SOCKET HE

The contract specifies the procurement of four socket head cap screws identified by NSN 5305-01-608-4920 under solicitation SPE4A6-26-T-04UN, with a delivery deadline of 138 days after award. Technical and quality requirements are governed by the DLA Master List of Technical and Quality Requirements, with compliance determined by the revision in effect on the solicitation issue date or award date depending on acquisition size. Packaging must adhere to DLA standards, and non-accepted supplies must have all government identification removed. Inspection and acceptance may occur at the manufacturer’s origin, and sampling follows MIL-STD-1916 or ASQ H1331 Table 1, employing zero non-conformances unless otherwise stated; critical, major, and minor attributes are assigned verification levels VII, IV, and II respectively. Tailored higher-level quality requirements apply to both manufacturers and non-manufacturers. The technical data associated with this item is subject to export controls under ITAR or EAR, restricting its disclosure to foreign persons without prior authorization from the Department of State or Commerce. Access is limited to contractors with approved JCP certification, completed mandatory training, and DLA authorization. DFARS 252.225-7048 governs handling of this controlled data, and covered defense information provisions are in effect. The solicitation was issued on July 8, 2026, with responses due by July 16, 2026, under the NAICS code 332722, managed by the Department of Defense’s ASC Commodities Division, with performance location in New Cumberland, PA, and primary point of contact Ashley JONES-TURNER.