SCREW, CLOSE TOLERAN

The contract solicitation SPE4A6-26-T-70S7 pertains to the procurement of 182 units of a screw with close tolerance, identified by NSN 5305012373036, manufactured to meet the non-government specification NAS1580 Revision 16 dated April 30, 2024, and referenced alongside NAS4004 Revision 16. The item is designated as a critical application component, and compliance with stringent technical and quality standards is mandatory, including the incorporation of requirements from the DLA Master List of Technical and Quality Requirements identified by R and I numbers. Quality assurance mandates sampling in accordance with MIL-STD-1916 or ASQ H1331 Table 1, with zero non-conformances required unless otherwise stated; attribute verification levels are defined as VII for critical, IV for major, and II for minor characteristics, corresponding to AQLs of 0.1, 1.0, and 4.0 respectively. Identification marking must conform to MIL-STD-130N paragraph 4.1.b(2), including manufacturer's logo, lot number, and material identification, in addition to bare item marking per RQ017, while shipping labels must adhere strictly to MIL-STD-129 with a special marking code of 00-00 indicating no additional special marking. Packaging must comply with MIL-STD-2073-1E and RP001 DLA Packaging Requirements, with each fastener individually protected along its full shank and thread length by a wrap or sleeve under packaging code ZZ, and no preservation, wrapping, or cushioning materials are to be used beyond this mechanical protection. Delivery is required FOB origin with a 164-day delivery window, and the sole destination is the DLA Distribution Depot in Tinker Air Force Base, Oklahoma, where both inspection and acceptance will occur. The item is to be shipped via parcel post or freight to the designated address, with palletization governed by DLA standards. The contract mandates compliance with a range of FAR and DFARS clauses, including those addressing employment eligibility verification, combating human trafficking, sustainable products, cybersecurity safeguards per NIST SP 800-171, safeguarding covered defense information, prohibition on acquiring certain telecommunications equipment, and whistleblower rights notification. Contractors must adhere to electronic invoicing exclusively through WAWF and maintain active SAM