SCREW SPECIAL

This contract, issued under solicitation number SPE4A6-26-T-14PG by the Defense Logistics Agency Aviation, Commodities Division, calls for the procurement of five units of a screw part identified by NSN 5305004685064, with a required delivery within 107 days from the award date. The item must comply with all technical and quality requirements specified in the DLA Master List of Technical and Quality Requirements, including physical identification marking (RQ017), packaging standards (RP001), and sampling protocols. Sampling must follow MIL-STD-1916, ASQ H1331 Table 1, or a comparable zero-based plan, with critical, major, and minor attributes assigned verification levels of VII, IV, and II or AQLs of 0.1, 1.0, and 4.0 respectively; unspecified attributes are considered major. Packaging must adhere to ASTM D3951 unless superseded by DLA standards, and all labeling and palletization must conform to MIL-STD-129 and RP001, with unit of issue and quantity per unit pack as defined in the contract. The delivery is FOB origin to the destination facility at 2083 Normandy Drive, New Cumberland, PA, with inspection and acceptance also occurring at destination. Payment processing must occur through the WAWF system, requiring submission of both an invoice and receiving report, and fast pay is not applicable. The contract incorporates multiple FAR and DFARS clauses, including provisions on cybersecurity safeguarding, trafficking in persons, employment eligibility verification, sustainable products, and hazardous material handling, all subject to deviation 2026-00038. The Berry Amendment applies with a $150,000 threshold, and use of additive manufacturing is strictly prohibited unless explicitly authorized. Offerors must be registered in the System for Award Management, submit safety data sheets prior to award, and must not provide covered telecommunications equipment as defined by FAR and DFARS clauses. Submitting quotes via DIBBS by the August 17, 2026 deadline is mandatory, and the solicitation may proceed via automated award unless first article test requirements are present, which would disqualify it. The contractor must comply with domestic material sourcing mandates and register with DLA’s AMPS system to access the Vendor Shipment Module within two months of award or face shipment denial.