SOLE SOURCE- QTY 200 7-PIN DIODE BLOCK

N00164-18-Q-0182- SOLE SOURCE- QTY 200 7-PIN DIODE BLOCK- FSG 5998- NAICS 334416 ISSUE DATE 06 MAR 2018 - CLOSING DATE 14 MAR 2018 -12:00 PM Eastern Time ITEM DESCRIPTION- Qty. 200- 7-Pin Diode Block Crane PN: 80952703-1. A high voltage, high frequency, dual, full bridge, single phase rectifier operating at 80kHz to produce a 2000Vdc output at 1Adc. It must have the capabilities to provide high electrical insulation so the device doesn't arc or produce corona but must have low thermal impedance so the device does not go into thermal runaway and burn up. The 7-Pin Diode Block is used in the ALQ-184 system for the F-16 Fighter Jet. SOLE SOURCE PROCUREMENT- The proposed contract action is for the supplies or services for which the Government intends to solicit and negotiate with one source; Julyn Technologies, Inc. 1003 Teresa Drive, Lake Park, GA. 31636 under the authority of FAR 6.302-1 only one source will satisfy the requirement. This is being sole sourced because this product must be compatible in all aspects with existing systems presently installed. All responsible sources may submit a capability statement which shall be considered by the agency. However, a determination by the Government not to compete with this proposed contract based upon responses to this solicitation is solely within the discretion of the Government. Information received will normally be considered solely for the purpose of determining whether to conduct a competitive procurement. Contractors must be properly registered in the System for Award Management (SAM). Offerors may obtain information on SAM registration and annual confirmation requirements by calling +1 (555) 000-0000 or via the internet at https://sam.gov. This solicitation is being issued pursuant to the procedures at FAR Part 13. Synopsis exception FAR 5.202(a)(13) applies and Solicitation Number N00164-18-Q-0182 is hereby issued as an attachment hereto. All changes to the requirement that occur prior to the closing date will be posted via FedBizOpps. It is the responsibility of interested vendors to monitor the FedBizOpps site for amendments that may be issued to this solicitation. For changes made after the closing date, only those offerors that provide a proposal will be provided any changes/amendments and considered for future discussions and/or award. Email to contact@example.gov. All required information must be received on or before 14 MAR 2018 12:00 PM EASTERN TIME.