SPACER, AXLE, LANDING

The contract solicitation SPE4A7-26-T-620M seeks the procurement of 216 units of SPACER, AXLE, LANDING GEAR with NSN 5365-00-605-3260 under simplified acquisition procedures, with delivery required within 32 days to Tinker AFB, Oklahoma. Technical and quality requirements are derived from the DLA Master List of Technical and Quality Requirements, and the item is subject to tailored higher-level contract quality requirements applicable to both manufacturers and non-manufacturers. Inspection and acceptance must occur at origin, with the contractor responsible for ensuring full compliance with DLA packaging standards RP001 and MIL-STD-2073-1E for preservation and packaging, including unit packaging code E5, preservation method 33, and clean and dry conditions. Marking and labeling must follow MIL-STD-129, incorporating bare item marking per RQ017, hazard communication standards, and UDI barcode requirements, with no special marking code specified. The item involves export-controlled technical data governed by ITAR or EAR, restricted to DLA contractors with approved JCP certification, completed DOD export training, and DLA authorization. Contractors must maintain CMMC Level 2 certification, comply with NIST SP 800-171 for safeguarding covered defense information, and adhere to basic safeguarding requirements for contractor information systems, including cybersecurity incident reporting obligations. All invoicing must be submitted electronically via WAWF, and payment routing depends on DoDAAC codes. The contract includes multiple FAR and DFARS clauses governing inspection, changes, subcontracts, payment, and compliance with prohibitions on hexavalent chromium, toxic materials, and purchase from communist Chinese military companies. The contract type is not explicitly stated but is consistent with firm-fixed-price terms under simplified acquisition procedures. No pricing information is provided in Section B, and the contract value remains undetermined. The solicitation closed on August 13, 2026, and submissions were required through the DIBBS portal.