SPRING, HELICAL, TORS

The contract solicits two helical torsion springs identified by NSN 5360-00-711-1806 under solicitation SPE7L1-26-T-626Z, issued by the Defense Logistics Agency’s Land Supply Chain. The item must comply with Basic Drawing NR 19200 7793252, Revision F, and incorporate all technical and quality requirements listed under RA001 in the DLA Master List of Technical and Quality Requirements. Deliverables are due within 20 days ADO, with a required delivery date of June 2, 2026, and must be shipped to the Ordnance Readiness Development Center in Ji Ji Township, Nantou, Taiwan, under FOB Origin terms per clause 52.247-29 despite the FMS designation for Taiwan. Packaging must adhere to MIL-STD-2073-1E with specific preservation, wrapping, and unit container codes, and marking must follow MIL-STD-129 without special markings. The springs must not come into direct contact with mercury except where functionally permitted under NAVSEA 5100-003D. Technical data associated with this item is subject to export controls under ITAR or EAR, restricting disclosure to foreign persons and requiring DLA-approved contractors to hold JCP certification, complete DOD export-controlled data training, and pass the DLA questionnaire. Cybersecurity requirements mandate CMMC Level 2 certification for third-party assessors, and the contractor must comply with Safeguarding Covered Defense Information and Cyber Incident Reporting (252.204-7012) and prohibitions on covered telecommunications equipment (252.204-7018). The contract incorporates provisions on whistleblower rights, disclosure of information, trafficking in persons, equal opportunity for workers with disabilities, and mandatory SAM registration with deviation 2026-00038. Invoicing must be processed through WAWF, and hazardous materials must be labeled per OSHA’s Hazard Communication Standard with supporting MSDS submitted. The solicitation is not set-aside for small businesses and requires DPAS DX or DO priority ratings. Offerors must maintain current SAM registration and comply with all representations, including small business status and telecommunications equipment disclosures, and must ensure compliance with applicable federal, state, and local regulations for safety and hazardous materials handling. Inspection and acceptance are to