This Government Contract opportunity from Department Of Defense was posted on April 27, 2026. The submission period has ended. Browse the details below for market research, or find similar active opportunities.

Top

Structural Angle Supply (20 Each)

Closed

Federal

Submission Closed05/06/2026, 07:00:00 PM UTC

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

Active Opportunities Like This One

NAICS: 332312

New

ACE-1199-1386-00 Tower Design and Fabrication for Various RCAG/RTR Sites (ADM, DPA, ONL, and RWF)

Solicitation # ace-1199-1386-00-tower-design-fabrication-various-rcagrtr-sites-adm-dpa-onl-rwf

Parsons Corporation is soliciting bids for the design, fabrication, and delivery of towers for various RCAG/RTR sites located in Oklahoma, Illinois, Nebraska, and Minnesota, specifically serving the ADM, DPA, ONL, and RWF locations. This project falls under NAICS code 332312 and requires that the selected offeror be fully bonded and insured to perform the work. The opportunity is set aside for small businesses, including certified Veteran Owned, Service-Disabled Veteran Owned, Women-Owned, and HUBZone small businesses. Interested parties must submit their responses by November 2, 2026. The primary point of contact for this solicitation is Thomas Sheehan.

POSTED

DEADLINE

Solicitation # SPE7M0-27-T-0724

DLA WEAPONS SUPPORT MARITIME SUPPLY CHAIN ESOC BUYS

POSTED

DEADLINE

SCREW, CLOSE TOLERANCE

Solicitation # SPE4A6-27-T-7135

DLA WEAPONS SUPPORT ASC COMMODITIES DIVISION

POSTED

DEADLINE

Tunnel Liner Plate Material Supplier

Dot084500 Capital Program Administration Dotd8, Dot-dept Of Transportation

POSTED

DEADLINE

Aluminum Fabrication and Welding for HWRS Units

Nuwc Division Newport

POSTED

DEADLINE

Integrated Water Tank and Storage FabricationThis subcontract involves the fabrication and supply of integrated water tank and fuel storage assemblies for prime contractors supporting DLA Troop Support projects. The scope of work requires the manufacture of an insulated potable water tank with a minimum capacity of 80 gallons, featuring an integrated storage rack capable of holding at least five 5-gallon fuel cans. The selected provider is responsible for the delivery of the fully installed assembly. The project is categorized under NAICS code 332312 and will be performed in Natick. Interested parties must adhere to the response deadline of November 4, 2026. This effort is managed under the Department of Defense for the DLA Troop Support agency.

POSTED

DEADLINE

Tactical Chassis FabricationThe Tactical Chassis Fabrication subcontract, issued by the Department of Defense under agency W6QK Acc-Apg, involves the production of lightweight and ruggedized housing and chassis for aircraft interior decontamination projects. These components are designed for the Joint Project Manager for CBRN Special Operations Forces and must be manufactured using composite materials and lightweight alloys. Each enclosure is required to fit within a 42 by 18 by 18 inch envelope and maintain a total weight of 150 pounds or less. To ensure operational viability, all deliverables must adhere to MIL-STD-1472 human engineering and lift requirements, resulting in a transportable chassis with integrated stowage. The project is categorized under NAICS code 332312 and will be performed in Abell. Interested parties must submit their responses by the deadline of November 24, 2026.

POSTED

DEADLINE

Stator Core Lamination Fabrication

POSTED

DEADLINE

Steel and Other Metal Materials for the Marietta Repair Station: Stamford De-Watering Box Material PH 1

Solicitation # W9123727QA011

Solicitation W9123727QA011 is a firm-fixed price commercial supply contract issued by the US Army Corps of Engineers, Huntington District, for the procurement of various steel and metal materials to support the Stamford De-Watering Box project at the Marietta Repair Station in Ohio. This procurement is a 100 percent small business set-aside under NAICS code 332312. The required materials include a wide array of ASTM standard products, specifically ASTM 1018 CR round bars, ASTM A434 CL bc, ASTM A53 seamless pipe, ASTM 1026 seamless tubing, ASTM A36 plates and bars, ASTM A709 Gr 50 plates, T-beams, and flat bars, as well as ASTM A325 fasteners. Specialized fabrication is required for certain ASTM 709 Gr 50 plates, including 1/8 inch tolerances and 45-degree double bevels as specified in the technical drawings. The selected vendor is responsible for arranging shipping to the Marietta Repair Station, with the government handling the unloading of materials upon arrival. All deliveries must be completed within eight weeks of the award date and must be accompanied by traceable mill certifications and testing reports. To be eligible for award, firms must be registered in the System for Award Management and comply with DFARS clauses 252.225-7001 and 252.225-7002 regarding the Buy American and Balance of Payments Program and Qualifying Country Sources as Subcontractors. The contract will be awarded using simplified acquisition procedures, and final invoicing is to be submitted via email once all materials are delivered onsite.

W072 Endist Huntington

POSTED

DEADLINE

Solicitation # SPE8EF-27-T-0145

CONSTRUCTION & EQUIPMENT MANU & CON

POSTED

DEADLINE

Environmental Control Work Booth/ Sanding Booth.

Solicitation # FA480027Q0005

The 633rd Contracting Squadron at Langley Air Force Base is conducting market research via a Sources Sought notice to identify capable companies for the procurement of an Environmental Control Work Booth/Sanding Booth. This self-contained system will be used for sanding and preparing aircraft components at the 1st Fighter Wing's Low Observable Consolidated hangar at Joint Base Langley-Eustis. The booth must measure 22 feet wide, 8 feet deep, and 8 feet high, featuring two 15 hp motors rated at 20,000 cfm and a filtration system consisting of 24 flame retardant Nanofiber cartridge filters and HEPA afterfilters capable of collecting hexavalent chromium particulate. The system must integrate with 600V power, fire suppress water lines, and direct air lines provided by the MAC contractor. This is currently a Request for Information and not a formal solicitation. Interested small businesses under NAICS 332312 are invited to provide feedback on the Statement of Requirements and the feasibility of a 12 to 14 week delivery timeline. A site visit is scheduled for November 3, 2026, at 2:00 PM EST, requiring attendees to wear OSHA-approved hard hats and reflective vests. Responses must be submitted on company letterhead via email to Kelly Voigts by November 13, 2026. Final delivery of the equipment is expected on or before February 5, 2027.

POSTED

DEADLINE

Purchase of 2 or 3 Temporary Road Bridges

Solicitation # 12444627Q0004

Solicitation 12444627Q0004 is a Request for Quotation issued by the Department of Agriculture for the purchase of two to three 20-foot temporary road bridges for the Superior National Forest. This acquisition is a Total Small Business Set-Aside under NAICS code 332312, with a size standard of 25 million dollars. The bridges must be delivered to the Isabella Work Station Storage Yard in Isabella, Minnesota, with the FOB point established as the contractor's facility. Technical specifications require adherence to AASHTO LRFD Bridge Design Specifications for deflection and AASHTO M168 for lumber and timber, with specific requirements for ASTM A307 galvanized hardware and AWPA-compliant copper naphthenate treatment. Award will be granted to the highest technically rated offeror, provided the price is fair and reasonable and past performance is acceptable or neutral. Evaluation focuses on the technical approach, specifically the ability to meet schedule requirements and a thorough understanding of the Statement of Work. Interested small businesses must submit a signed SF1449, a completed Schedule of Items, and a technical narrative in PDF format to Debra Derickson by November 10th at 1:00 PM Central Time. The contract is governed by FAR Part 12 for commercial items and includes various federal and agency-specific clauses regarding security, whistleblower rights, and electronic payment submissions.

Csa East 7 Usda-Fs

POSTED

about 19 hours ago

DEADLINE

in 14 days

AI Contract Overview

The contract requires the supply of twenty structural angle units to support construction or repair projects, with all items needing to meet strict Department of Defense packaging, marking, and cybersecurity standards prior to delivery to Japan. The solicitation is structured as a subcontract and is set aside exclusively for small businesses under the SBA’s Total Small Business Set-Aside program, as defined by FAR 19.5, with the assigned NAICS code 332312 indicating manufacturing of structural metal products. The offering organization is the Navy Supply Systems Command Fleet Logistics Center Puget Sound, operating under the Department of Defense, and responses must be submitted by May 6, 2026, at 7:00 PM Eastern Time. The items must be fully compliant with DOD cybersecurity protocols to ensure secure handling and data integrity throughout the supply chain, and packaging and marking must conform to all federal military specifications for international shipment.

General Info

Supply 20 structural angles to Japan, small business set-aside, comply with DOD packaging, marking, cybersecurity.

Agency

Department Of Defense → Navsup Flt Logistics Ctr Puget Sound

NAICS

332312 - Fabricated Structural Metal Manufacturing

Place of Performance

Set-Aside

SBA

Documents

This scope was carved out of N0040626Q0083.

The full solicitation package (3 documents), including the RFP, is on the prime solicitation, not on this scope.

View the prime solicitation

9520 Structural Steel (Tee, Pipe, Channel & Angle)

AI Contract Breakdown

Uniform Contract Format

No documents to break down

The breakdown needs solicitation documents. None were found from this contract's source.

Timeline

PhaseClosed

PostedApr 27

subcontract

Response DeadlineMay 6

Deadline has passed

Submission Closed

05/06/2026, 07:00:00 PM UTC

Find active opportunities like this

Start your free trial to discover similar active contracts, track opportunities, and build proposals with AI assistance.

Organization & Contact Information

AgencyDepartment Of Defense → Navsup Flt Logistics Ctr Puget Sound

ContactsNo contacts available

OfficeN/A

Organization / AgencyDepartment Of Defense → Navsup Flt Logistics Ctr Puget Sound

Office AddressN/A

ContactsNo contact information available

Full Description

Bulk supply of 20 structural angle units for construction or repair projects, with full compliance with DOD packaging, marking, and cybersecurity requirements for delivery to Japan.