Trim, Soffit and Fascia - Roger St.

The scope of work required under this request includes Replacement of Trim, Soffit and Fascia at Roger Street Units in Sarnia, ON. A portion of the units have been completed and the County will work with thesuccessful contractor to complete the remainder of the units.Work must commence and be completed in accordance with the schedule provided. Bidders must view the attached drawing typical for Roger St. Units and supply pricingof the work to be completed at the locations listed below on the form oftender.Work must be completed in accordance with the schedule provided. The Successfulcontractor will be responsible for providing written notice to each tenant ofthe work. Notices must be provided with a minimum of 48 hours' notice. It isextremely important that dates provided within notices be honoured. Once work commences, the County requires that the project be worked on continuouslyuntil complete. No lapse or interval will be allowed.On occasion other related work will be required. The County will whenever possible request that the successful contractor complete the work on a time and materials basis utilizing the hourly rates provided on the form of tender. Hourly rates must include all associated expenses such as tools, trucks, etc. No additional costs beyond the hourly rate such as fuel surcharges or other expenses will be allowed or considered.Remove and dispose of the existing metal ridge vents and cap along with any foam closure. Supply and install new "rapid ridge roll vent" complete with new 26 gauge metal ridge cap complete withmetal rib fillers and foam closures as per drawing.Remove existing gable end trims and replace with new 26 gauge steel trims as per drawings.Remove existing metal soffit/ fascia and replace with new one piece vented 26 gauge steel trims as perdrawings.Rework existing vinyl siding carefully as required to complete soffits, trims, fascias and gable flashings. Remove carefully and reinstall gutters and downspouts as required to permit installation of new sheet metalflashings. Supply and install new wood blocking/ backing as required to suit new trim profiles. Contractor to site verify ALL dimensions of trims prior to fabrication