TUBE, INJECTOR

TUBE,INJECTOR
TUBE,INJECTOR
RC001: DOCUMENTATION REQUIREMENTS FOR SOURCE APPROVAL REQUEST (SAR)
RD002, COVERED DEFENSE INFORMATION APPLIES
RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT:
http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx
FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS.
RQ009: INSPECTION AND ACCEPTANCE AT ORIGIN
RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES
SAMPLING:
THE SAMPLING METHOD SHALL BE IN ACCORDANCE WITH MIL-STD-1916 OR ASQ
H1331, TABLE 1 OR A COMPARABLE ZERO BASED SAMPLING PLAN UNLESS OTHERWISE
SPECIFIED BY THE CONTRACT. IF THE APPLICABLE DRAWING, SPECIFICATION,
STANDARD, OR QUALITY ASSURANCE PROVISION (QAP) SPECIFIES CRITICAL, MAJOR
AND/OR MINOR ATTRIBUTES, THEY SHALL BE ASSIGNED VERIFICAITON LEVELS OF
VII, IV AND II OR AQLS OF 0.1, 1.0 AND 4.0 RESPECTIVELY. UNSPECIFIED
ATTRIBUTES SHALL BE CONSIDERED AS MAJOR UNLESS SAMPLING PLANS ARE
SPECIFIED IN APPLICABLE DOCUMENTS. FOR MIL-STD-1916, THE MANUFACTURER
MAY USE THE ATTRIBUTE OR VARIABLE INSPECTION METHOD AT THEIR OPTION OR
PER THE CONTRACT. MIL-STD-105/ASQ Z1.4 MAY BE USED TO SET SAMPLE LOT
SIZE, BUT ACCEPTANCE WOULD BE ZERO NON-CONFORMANCES IN THE SAMPLE LOT
UNLESS OTHERWISE SPECIFIED IN THE CONTRACT.
HAMILTON SUNDSTRAND CORP
RD004: Cybersecurity Maturity Model Certification (CMMC) Level 2 Self-Assessment RD004: Cybersecurity Maturity Model Certification (CMMC) Level 2 Self-Assessment RQ017: PHYSICAL IDENTIFICATION/BARE ITEM MARKING
APPROVED SOURCES:
SEE AMPL/HERS FOR CAGE & P/N
CRITICAL CHARACTERISTICS: (MANUFACTURE / INSTALLATION / DEPOT CRITICAL)
TESTING REQUIREMENTS:
THIS COMPONENT CONTAINS NO SUBCOMPONENTS.
NOT ESTABLISHED AS A SINGLE COMPONENT. BUY FROM APPROVED SOURCES.
ENGINEERING Y TESTING Y FATIGUE Y ENDURANCE Y INTERCHANGE Y
SPE4A7-27-T-3781
SECTION B
CONFIGURATION CONTROL APPLIES
FURNISHED ITEM MUST CONFORM TO THE CITED
REQUIREMENTS/REVISION. VARIATIONS MUST BE
IDENTIFIED AND APPROVAL OBTAINED IN ACCORDANCE
WITH MIL-STD-973 DATED 17 APR 92 AND INTERIM
NOTICE 3 DATED 13 JAN 95. PARAGRAPH 5.4.2
REQUIREMENTS FOR ENGINEERING CHANGE PROPOSALS
AND APPENDIX D NSN/Part Number: 2915-01-087-4172 Quantity: 4 EA Purchase Request: 7015679869QTY: 4 Delivery: 155 days ADO