Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, October 28 at 2:00 PM ET

Register Free →

This Combined Synopsis/Solicitation opportunity from Department Of Defense was posted on May 28, 2026. The submission period has ended. Browse the details below for market research, or find similar active opportunities.

WAVEFORM GENERATOR

Closed
N0016426Q0164Federal

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

Active Opportunities Like This One

AI Contract Overview

Show more

The U.S. Navy’s Naval Surface Warfare Center Crane is seeking to procure ten Arbitrary Waveform Generators with part number 670C-4C-2256M-HV4-GPIB under a sole source acquisition through a Firm Fixed Price Request for Quotes issued pursuant to FAR 12.201-1. The requirement is specifically for units capable of generating synchronized, complex waveforms across four independently controlled analog channels with a minimum sampling rate of 100Msa/s and an ideal rate of 600Msa/s, 16-bit vertical resolution, and jitter under 2 picoseconds. Each channel must support voltages up to 12Vpp on a 50ohm load and offsets from -6V to +6V, with a minimum memory of 256Ms and dual communication interfaces via GPIB and LAN, all compatible with SCPI commands. The devices must also include a physical display and controls for manual operation. The sole source is BNC Corp of San Rafael, California, identified by CAGE code 23908, as they are the only U.S.-based supplier whose waveform generators meet the precise technical and firmware requirements necessary for integration into Aegis test systems at Crane and external vendor sites; no other provider can deliver the necessary performance without additional development or resource expenditure. The solicitation number is N0016426Q0164, with submissions due by June 8, 2026, at 11:00 PM Eastern Time via email to [email hidden]. All offerors must be currently registered in the System for Award Management and comply with applicable representations and certifications incorporated by reference, including those concerning cybersecurity (NIST SP 800-171), counterfeit part avoidance, electronic part sourcing, and defense information safeguarding. The acquisition is subject to DPAS rating DO-A7 for national defense priority, and compliance with the Buy American Act and several federal statutes governing procurement integrity, kickbacks, labor standards, and restrictions on influencing federal transactions. Delivery is required at NSWC Crane’s receiving facility in Crane, Indiana, within six weeks of contract award, with shipping costs covered under a separate CLIN. Items must be uniquely identified and marked in accordance with MIL-STD-130 and MIL-STD-129, with all marks machine-readable and verified using approved automatic identification technology. In

General Info

NSWC Crane sole source buys ten BNC Arbitrary Waveform Generators meeting strict technical specs.

NAICS

334515 - Instrument Manufacturing for Measuring and Testing Electricity and Electrical Signals

Place of Performance

Crane, IN, 47522, USA

Set-Aside

NONE

Documents

1

N0016426Q0164 Arbitrary Waveform Generator RFQ

PDF, High priority: read this firstrfq
High

AI Contract Breakdown

Uniform Contract Format

Sign up to view the full breakdown with detailed analysis of each section.

Timeline

PhaseClosed
Posted

Combined Synopsis

Response Deadline

Deadline has passed

Submission Closed

Find active opportunities like this

Start your free trial to discover similar active contracts, track opportunities, and build proposals with AI assistance.

Organization & Contact Information

Show more
AgencyDepartment Of Defense → Nswc Crane
Contacts2 people available
OfficeCRANE, IN, 47522-5001, USA
Office AddressCRANE, IN, 47522-5001, USA

Full Description

Show more

N0016426Q0164 – SOLE SOURCE - Waveform Generator – FSG 6115 – NAICS 334515


ISSUE DATE 28-MAY-2026 – CLOSING DATE 08-JUN-2026 – 11:00 PM Eastern Time


ITEM DESCRIPTION- Naval Surface Warfare Center (NSWC) Crane has a requirement for a quantity of ten (10) Arbitrary Waveform Generators (AWG) Part Number 670C-4C-2256M-HV4-GPIB with specific salient characteristics.


  • Must have 4 independently controlled analog channels (minimum)
  • Must support up to 12Vpp on 50ohm for each analog channel (minimum)
  • Must support offsets from -6 to +6V on 50ohm for each analog channel (minimum)
  • Must have a Sampling rate of 100Msa/s (minimum) and 600Msa/s (ideal)
  • Must have GPIB interface for communication
  • Must have LAN interface for communication
  • Must support SCPI communication
  • Must have 256Ms memory (minimum)
  • Must allow the ability to play complex waveforms (sequences/segments) and synchronize them between all 4 analog channels for continuous playback.
  • Must allow for the building, playback, and control of all operations via remote GPIB and LAN interface.
  • Must have a physical screen and buttons to show status and allow manual control of the device.
  • Must have 16 bits of vertical resolution (minimum)
  • Must have a jitter of less than 2 picoseconds (minimum)

SOLE SOURCE PROCUREMENT- The proposed contract action is for the supplies or services for which the Government intends to solicit and negotiate with one source, limited sources or brand name only BNC CORP of Sand Rafael, California, cage code 23908, under the authority of FAR 12.201-1 for Commercial items using simplified procedures. This is being solicited on a sole source only basis because The required Arbitrary Waveform Generators (AWG) will be used to provide various synchronized pulses to modulators and test equipment throughout Aegis test sets at Crane and external vendor facilities. This purchase is specific to BNC Corp (Berkeley Nucleonic Corp) as they are the only direct supplier of AWG in the U.S. that meet the specified characteristics required. The BNC Corp AWGs have been tested and approved as the best equipment to perform within the Aegis test sets. Any provider outside of BNC Corp, may not provide the specific characteristic required or the firmware for the units to be able to be used without further resources being expended.  All responsible sources may submit a capability statement, which shall be considered by the agency. However, a determination by the Government not to compete with this proposed contract based upon responses to this solicitation is solely within the discretion of the Government. Information received will normally be considered solely for the purpose of determining whether to conduct a competitive procurement.


Contractors must be properly registered in the System for Award Management (SAM). Offerors may obtain information on SAM registration and annual confirmation requirements by calling +1 (555) 000-0000 or via the internet at https://sam.gov.


This solicitation is being issued pursuant to the procedures at FAR 12.201-1 as a written Firm Fixed Priced Request for Quotes .  Synopsis exception FAR 5.202(a)(13) applies and Solicitation Number N0016426Q0164 is hereby issued as an attachment hereto. 


All changes to the requirement that occur prior to the closing date will be posted to Contract Opportunities on https://sam.gov/.  It is the responsibility of interested vendors to monitor https://sam.gov/ for any amendments, which may be issued to this solicitation. 


For changes made after the closing date, only those offerors that provide a quote will be provided any changes/amendments and considered for future discussions and/or award.


Offers shall be e-mailed to contact@example.gov. All required information must be received on or before


08-JUN-2026 – 11:00 PM Eastern Time.


More opportunities from Department Of Defense → Nswc Crane

Same awarding agency

NAICS: 336510
New
Federal
N0016426RGW20-PROCUREMENT OF DESIGN AND PRODUCTION OF FLAT RAILCARS-PSC 2220- NAICS 336510
Solicitation # N0016426RGW20
Solicitation N0016426RGW20 is an IDIQ contract issued by the NSWC Crane Warfare Center for the design and production of NSWC AIM Flatcars. The project involves the development and manufacture of a maximum quantity of nine railcars that must be fully commissioned and approved for use by the AAR. Key technical specifications include a lightweight car requirement of 116,000 pounds, truck axle loads not exceeding 60,000 pounds per axle, and adherence to AAR-M1001 Section C, Part II. The scope also incorporates specific load securement standards from WS20972 and MIL-SPC-810, and utilizes the Trident II AIM Flatcar / SSE Interface Drawing 5681514. The period of performance is structured over five years from the date of award. Delivery is required for three Strategic Weapons Facility locations, with risk handled under FOB terms. Evaluation criteria include a comparative analysis of delivery pricing for the three shipping locations and an assessment of past performance on non-federal government contracts related to rail car design and manufacture. Following several amendments to update the Statement of Work, revise requirement documents, and provide answers to offeror questions, the final closing date for proposal receipt was extended to November 25, 2026, at 2:00 PM EST. The primary point of contact for this procurement is Steven Junkins.
Railroad Rolling Stock Manufacturing

POSTED

2 days ago

DEADLINE

in 28 days
View Details

Find Active Opportunities Like This

Get AI-powered intelligence on the opportunities still open

Every page of the solicitation package shredded into a compliance breakdown

AI-powered matching based on your capabilities and past performance

Competitor and incumbent history on the requirement

Automated alerts on amendments, Q&A deadlines, and award

Miguel
Hillary
Keith Deutsch
Christine

Join 750+ contractors already using CLEATUS