BATTERY, STORAGE

BATTERY,STORAGE
BATTERY, STORAGE
RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT:
http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx
FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS.
RQ001: TAILORED HIGHER LEVEL CONTRACT QUALITY REQUIREMENTS
(MANUFACTURERS AND NON-MANUFACTURERS)
RQ002: CONFIGURATION CHANGE MANAGEMENT ENGINEERING CHANGE PROPOSAL
REQUEST FOR VARIANCE (DEVIATION OR WAIVER)
RQ009: INSPECTION AND ACCEPTANCE AT ORIGIN
RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES
RQ016: COMPONENT QUALIFIED PRODUCTS LISTS (QPL)/QUALIFIED MANUFACTURERS
LISTS (QML). THIS ITEM CONTAINS ONE OR MORE COMPONENTS DEFINED BY A
SPECIFICATION(S) WITH AN ASSOCIATED QUALIFIED PRODUCTS LIST (QPL) OR
QUALIFIED MANUFACTURERS LIST (QML). QUALIFICATION REQUIREMENTS IN
PROCUREMENT NOTE H02 "COMPONENT QUALIFIED PRODUCTS LIST (QPL)/QUALIFIED
MANUFACTURERS LIST (QML)" APPLY.
RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
RT001: MEASURING AND TEST EQUIPMENT
NICKEL CADMIUM, WET
THIS NSN CONTAINS ONE OR MORE COMPONENTS WHICH MUST MEET QPL/QML
REQUIREMENTS. BY SUBMITTING AN OFFER, THE OFFEROR AGREES TO PROVIDE
QPL/QML COMPONENTS ONLY FROM SOURCES QUALIFIED ON THE APPLICABLE
QPL(S)/QML(S).
Hazard Communication Standard Notice:
Effective June 1, 2015, Federal Standard No. 313-E, Material Safety Data, Transportation Data and Disposal Data for Hazardous Materials Furnished to Government Activities, establishes the requirement for
SPE7L7-26-T-4507
SECTION B
preparation and submission of Safety Data Sheets (SDS) in lieu of Material Safety Data Sheets (MSDS) by suppliers who provide hazardous materials to government activities.
The Occupational Safety and Health Administration (OSHA) has modified its Hazard Communication Standard (HCS) to conform to the United Nations Globally Harmonized System of Classification and Labeling of Chemicals. As a result of this change, GSA revised Federal Standard No. 313-E requiring Safety Data Sheets for classifying chemicals and communicating the applicable information on labels.
In accordance with the revised standard after June 1, 2015:
1. Suppliers will be required to submit, to the contracting officer for review and approval prior to award, safety data sheets consistent with the requirements found at 29 C.F.R. 1910.1200 for hazardous materials delivered to the Government.
2. Suppliers will also be required to submit, to the contracting officer for review and approval prior to award, Hazardous Communication Standard (HCS) labels in accordance with 29 C.F.R. 1910.1200 requirements or current Consumer Product Safety Act (CPSA), Federal Hazardous Substance Act (FHSA) labels when subject to labeling requirements under those statutes. This product labeling is required for hazardous materials delivered to the Government.
3. Finally, suppliers must train their employees on the new safety data sheets, hazardous communication labels, and requirements of 29 C.F.R. 1910.1200.
For more information on SDS, refer to OSHAs website, available at:
https://www.osha.gov/law-regs.html
For information on 29 C.F.R. 1910.1200, refer to the below link:
https://www.osha.gov/dsg/hazcom/index.html PART NUMBER: D8565/10-1
MSDS/PSDS REQ. PER FED-STD-313
SHELF LIFE; TYPE 2, 60 MONTHS
NO CONTRACT LOTS SHALL BE RELEASED FOR SHIPMENT UNTIL LOT ACCEPTANCE
TESTING IS MET AND FINAL APPROVAL IS GIVEN BY THE QUALIFYING ACTIVITY.
TEST SAMPLES SHALL NOT BE INCLUDED IN CONTRACT QUANTITY.
********************************************************
EXCEPTION TO DATA:
: "THE REQUIREMENTS FOR ACQUIRING THE PRODUCTS
DESCRIBED HEREIN, P/N D8565/10-1 AND P/N D8565/10-2, SHALL CONSIST OF
THIS SPECIFICATION SHEET AND MIL-PRF-81757."
1) DELETE, "TYPE 2", FROM THE TITLE.
2) CHANGE THE WORDING,: "THE REQUIREMENTS FOR ACQUIRING THE PRODUCT
DESCRIBED HERE IN SHALL CONSIST OF THIS SPECIFICATION SHEET AND
MIL-PRF-81757." TO: "THE REQUIREMENTS FOR ACQUIRING THE PRODUCTS
DESCRIBED
HEREIN, P/N D8565/10-1 AND P/N D8565/10-2, SHALL CONSIST OF THIS
SPECIFICATION SHEET AND MIL-PRF-81757."
3) ALLOW USE OF EITHER THE P/N MS3509-28 RECEPTACLE OR THE NEWLY
QUALIFIED
P/N MS3509-32 RECEPTACLE.
4) MOVE THE HARNESS FUNCTION TYPE TESTS (10, 11, 12) TO GROUP B
5) ELIMINATE THE VENTED FILLER CAP TEST (9)
6) ALLOW THE USE OF EITHER AD590L OR AD590M
7) IN FIGURE 2, CHANGE #10-32 AN3C3A SCREW AT RECEPTACLE TO THE LONGER
AN3C5A SCREW.
8) REMOVE TEST #1 INCOMING INSPECTION FROM GROUP A.
SPE7L7-26-T-4507
SECTION B
9) REMOVE TEST #13 CONDITIONING CHARGE FROM GROUP A ONLY.
10) THE, "FOR NO LESS THAN 24 HOURS", SHALL BE REMOVED FROM THE STEP B
OF
4.5.32.
11) TABLE II: REMOVE TESTS #3, #4 & #5 FROM GROUP A
12) TABLE II: REMOVE DUPLICATIONS OF TESTS #3, #4 & #5
13) TABLE I TEST NUMBER 5 FOR GROUP A REQUIREMENT.
THE DIELECTRIC STRENGTH AND INSULATION RESISTANCE TEST:
NOT TO BE PART OF GROUP A TESTING.
EEXCEPTION WILL BE IN EFFECT ONLY UNTIL MIL-PRF-81757/17
HAS BEEN UPDATED BY NWSC CRANE.
END OF EXCEPTIONS.
******************************************************
I/A/W MIL-PRF-81757/17 (AS)
MERCURY OR MERCURY CONTAINING COMPOUNDS SHALL
NOT BE INTENTIONALLY ADDED TO<(>,<)> OR COME IN DIRECT
CONTACT WITH<(>,<)> ANY HARDWARE OR SUPPLIES FURNISHED
UNDER THIS CONTRACT. EXCEPTION: FUNCTIONAL MERCURY
USED IN BATTERIES, FLUORESCENT LIGHTS, REQUIRED
INSTRUMENTS; SENSORS OR CONTROLS; WEAPON SYSTEMS;
AND CHEMICAL ANALYSIS REAGENTS SPECIFIED BY NAVSEA.
PORTABLE FLUORESCENT LAMPS AND PORTABLE INSTRUMENTS
CONTAINING MERCURY SHALL BE SHOCK PROOF AND CONTAIN
A SECOND BOUNDARY OF CONTAINMENT OF THE MERCURY OR
MERCURY COMPOUND. (IAW NAVSEA 5100-003D).
RS062: Shelf life requirement RS001 for a TYPE 2 (CODE 9) item with a shelf life of 60 month (extendable) applies to this item.
CRITICAL APPLICATION ITEM
TDP Rev A Gen 1 IAW BASIC SPEC NR MIL-PRF-81757/17 NOT 1 REVISION NR DTD 05/15/2019 PART PIECE NUMBER: D8565/10-1
TDP Rev A Gen 1 IAW REFERENCE SPEC NR MIL-PRF-81757D(4) SUP 1 NOT 1 REVISION NR D DTD 04/06/2017 PART PIECE NUMBER:
TDP Rev A Gen 1 IAW REFERENCE UNK QPL-81757-16 NOT 1 REVISION NR 16 DTD 10/15/2007 PART PIECE NUMBER:
DLA issues this document using the DoD authorized unit of issue, please refer to the following URL to determine the corresponding ANSI X12 unit of issue.
https://view.officeapps.live.com/op/view.aspx?src=https%3A%2F%2Fwww.dla.mil%2FPortals%2F104%2FDocuments% 2FDLMS%2FeApplications%2FLogDataAdmin%2FUnitofIssueandPurchaseUnit.xlsx&wdOrigin=BROWSELINK
CLIN PR PRLI UI QUANTITY UNIT PRICE TOTAL PRICE.
0001 7017548761 0001 EA 32.000
NSN/MATERIAL:6140013854191
DELIVERY (IN DAYS):0140
SPE7L7-26-T-4507
SECTION B
PR: 7017548761 PRLI: 0001 CONT’D
DELIVER FOB: ORIGIN
QTY VARIANCE: PLUS 0% MINUS 0%
INSPECTION POINT: ORIGIN
ACCEPTANCE POINT: ORIGIN
PREP FOR DELIVERY:
PKGING DATA MIL-STD-2073-1E
QUP:001 PRES MTHD:HM CLNG/DRY:Z PRESV MAT:ZZ
WRAP MAT:ZZ CUSH/DUNN MAT:ZZ CUSH/DUNN THKNESS:Z
UNIT CONT:ZZ OPI:M
INTRMDTE CONT:ZZ INTRMDTE CONT QTY:ZZZ
PACK CODE:Q PACKING LEVEL: B
MARKING SHALL BE IN ACCORDANCE WITH MIL-STD-129.
SPECIAL MARKING CODE:33 -33 Type II, shelf life
PALLETIZATION SHALL BE IN ACCORDANCE WITH RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
IP025: PACKAGING, MARKING, AND SHIPPING OF HAZARDOUS MATERIALS
FREIGHT FORWARDER:
MULTIPLE FORWARDERS EXIST. TRANSPORTATION SEE DLAD PROC NOTE C19. FIRST DESTINATION TRANS SEE DLAD PROC
NOTE C20 AND CONTRACT
FREIGHT SHIPPING ADDRESS:
BTWZ00
TAIWAN ARMY
ZUO-YING AMMUNITION SUB
NO. 127, GUSHAN 3RD RD
KAOHSIUNG CITY
TW
MARKFOR
BTWZ00
TAIWAN ARMY
ZUO-YING AMMUNITION SUB
NO. 127, GUSHAN 3RD RD
KAOHSIUNG CITY
TW
M/F: (TCN) PTWZ5V61970002
RDD:
PROJ: TP 2
SUPP ADD: BA4KMX SIG: L
FOR GOVERNMENT USE ONLY: (IPD) 06
DIC: A01 DIST: F9B ADV: 2L FC: 48
Need Ship Date:00/00/0000 Original Required Delivery Date:07/22/2026
SPE7L7-26-T-4507
SECTION B
PR: 7017548761 PRLI: 0001 CONT’D
PRODUCTION LOT TESTING GOVERNMENT TESTING REQUIRED (REFER TO
PROCUREMENT NOTE E04 FOR ADDITIONAL INFORMATION)
DLA issues this document using the DoD authorized unit of issue, please refer to the following URL to determine the corresponding ANSI X12 unit of issue.
https://view.officeapps.live.com/op/view.aspx?src=https%3A%2F%2Fwww.dla.mil%2FPortals%2F104%2FDocuments% 2FDLMS%2FeApplications%2FLogDataAdmin%2FUnitofIssueandPurchaseUnit.xlsx&wdOrigin=BROWSELINK
CLIN PR PRLI UI QUANTITY UNIT PRICE TOTAL PRICE.
0002 0000000000 EA 1.000
NSN/MATERIAL:S00000061
DELIVERY (IN DAYS):0020
THIS LINE ITEM SIGNIFIES THE PRODUCTION LOT TEST REQUIREMENT (PLT).
DELIVER FOB: ORIGIN
QTY VARIANCE: PLUS 0% MINUS 0%
INSPECTION POINT: ORIGIN
ACCEPTANCE POINT: ORIGIN
Need Ship Date:00/00/0000 Original Required Delivery Date:00/00/0000
SPE7L7-26-T-4507 NSN/Part Number: 6140-01-385-4191 Quantity: 32 EA Purchase Request: 7017548761QTY: 32 Delivery: 140 days ADO