1. Advance Contract Award Notice (ACAN) An ACAN is a public notice indicating to the supplier community that Agriculture and Agri-Food Canada intends to award a contract for services to a pre-identified supplier, thereby allowing other suppliers to signal their interest in bidding, by submitting a statement of capabilities. If no supplier submits a statement of capabilities that meets the requirements set out in the ACAN, on or before the closing date stated in the ACAN, the Contracting Authority may then proceed with the award to the pre-identified supplier. 2. Definition of the requirement The Department of Agriculture and Agri-Food Canada has a requirement for Thermo Fisher Scientific Inc. to provide preventative maintenance services for one (1) Orbitrap ID-X, IC Ready Mass Spectrometer (Serial Number FSN30102) connected with Vanquish Binary Pump, Vanquish Split Sampler FT, and Vanquish Column Compartment H located at the Morden Research and Development Centre. The service will involve the following under an Essential Support Plan: - Field Service Engineer labor, travel, and parts required for any unlimited Corrective Maintenance visits within a 72h response time. - Technical Support inquiries with a targeted immediate response time provided by a certified service engineer using the latest digital remote support tools. - One (1) scheduled annual standard Preventive Maintenance visit including replacement parts (Standard PM Kit included). - Instrument Requalification (RQ) in conjunction with a scheduled Corrective Maintenance with a purchase of an add-on Operational Qualification. - Access to Unity Lab Services Online Knowledge Base subscription. - Software and firmware updates upon request and in conjunction with a scheduled Preventative Maintenance or Corrective Maintenance visit. - 10% discount on spare parts not covered by Corrective Maintenance, and accessories and consumables for the instruments, and 10% discounts off list price for any training classes purchased during the contract period. 3. Criteria for assessment of the Statement of Capabilities (Minimum Essential Requirements) Any interested supplier must demonstrate by way of a statement of capabilities that it meets the following requirements: - Are an authorized vendor who are certified and authorized to maintain and repair Orbitrap ID-X Mass Spectrometers and UHPLC Instruments to restore instruments operating as intended. 4. Applicability of the trade agreement(s) to the procurement This procurement is subject to the following trade agreement(s): Canadian Free Trade Agreement (CFTA) Canada-Chile Free Trade Agreement (CCFTA) Canada-Colombia Free Trade Agreement Canada-Honduras Free Trade Agreement Canada-Korea Free Trade Agreement Canada-Panama Free Trade Agreement Canada-Peru Free Trade Agreement (CPFTA) 5. Justification for the Pre-Identified Supplier Thermo Fisher Scientific owns the design of this equipment. There is no other company that can provide parts, training, service or repairs because the architecture and technology belong to Thermo Fisher Scientific. Since Thermo Fisher is the original manufacturer of this equipment, they are the only company that have trained service engineers that are qualified to do the trouble shooting and repairs on their technology should something break down. 6. Government Contracts Regulations Exception(s) The following exception(s) to the Government Contracts Regulations is invoked for this procurement under subsection. 6.(d) - "only one person or firm is capable of performing the work". Where, for works of art, or for reasons connected with the protection of patents, copyrights or other exclusive rights, or proprietary information or where there is an absence of competition for technical reasons, the goods or services can be supplied only by a particular supplier and no reasonable alternative or substitute exists. 7. Exclusions and/or Limited Tendering Reasons The following exclusion(s) and/or limited tendering reasons are invoked under the: Canadian Free Trade Agreement (CFTA) – Article(s) 513 (b) ii Canada-Chile Free Trade Agreement (CCFTA) – Article(s) Kbis-09 (b) Canada-Colombia Free Trade Agreement – Article(s) 1409 1. (b) Canada-Honduras Free Trade Agreement – Article(s) 17.11 (b) (i) Canada-Korea Free Trade Agreement – referencing the WTO Protocol Amending the GPA, Article XIII (1) (b) Canada-Panama Free Trade Agreement – Article(s) 16.10 (b) (ii) Canada-Peru Free Trade Agreement (CPFTA) – Article(s) 1409 (b) (ii) 8. Period of the proposed contract The proposed contract is for a period of 3 years, from estimated start date: January 15, 2027 to estimated completion date: January 14, 2030. 9. Cost estimate of the proposed contract The estimated value of the contract is $ 223,853.05 (including all applicable taxes). 10. Name and address of the pre-identified supplier Thermo Fisher Scientific (Mississauga) Inc. 4-2845 Argentia Road MISSISSAUGA, ON L5N 8G6 11. Suppliers' right to submit a statement of capabilities Suppliers who consider themselves fully qualified and available to provide the services described in the ACAN may submit a statement of capabilities in writing by Email to the Contracting Authority identified in this notice on or before the closing date of this notice. The statement of capabilities must clearly demonstrate how the supplier meets the advertised requirements. 12. Closing date for a submission of a statement of capabilities. The closing date and time for accepting statements of capabilities is December 1 at 11:00 a.m., CST. 13. Inquiries and statements of capabilities are to be directed to: Melissa Smith Procurement Specialist Agriculture and Agri-Food Canada Western Service Centre Telephone:
+1 (•••) •••-••••Sign up to see this detail Email address:
•••••@•••••.•••Sign up to see this detail Please note that the Department of Agriculture and Agri-Food Canada will not accept hard copy submissions. Email submissions must be less than 20 MB; if the file(s) are larger please split them into more than one email. Emails with links to bid documents will not be accepted. The Department is not responsible for misdirected or delayed submissions. All submissions must be received by the closing date and time specified above. All submissions should note the following file number in the subject line of the e-mail: # WSC-2627-200 Statement of Capabilities received on or before the closing date will be considered solely for the purpose of deciding whether or not to conduct a competitive procurement. Information provided will be used by AAFC for technical evaluation purposes only, and will not to be construed as a proposal. Your written Statement of Capabilities must provide sufficient evidence that demonstrates it is capable of fulfilling AAFCs requirement. Suppliers who submit a Statement of Capabilities prior to the closing date and time will be notified in writing as to the Department’s decision whether it will continue with the aforementioned procurement, or proceed to a full bid solicitation process. If other potential suppliers submit a statement of capabilities during the fifteen (15) calendar day posting period that meet the requirements set out in the ACAN, the government will proceed to a full tendering process on either the government's electronic tendering service or through traditional means, in order to award the contract. If no other supplier submits, on or before the closing date, a statement of capabilities meeting the requirements set out in the ACAN, a contract will be awarded to the preselected supplier.