Aircraft Ramp System Kits

[Amendment] P00002: The purpose of this modification is to provide responses to requests for information (RFIs). See attached amendment P00002. [Amendment] P00001: This is an amendment to solicitation W912D1-23-Q-0026. This solicitation is for the purchase and delivery of two (2) aircraft ramp system with the following salient characteristics: SALIENT CHARACTERISTICS: Ramps should have Tread Surface. Non-slip feature on ramp surface. Each ramp system should have a maximum axle weight capacity of 20,000lbs per paired ram section or aircraft limitations. Each ramp rated at 10,500 lbs. minimum. System must be modular and portable. System shall be stackable and compliant with HCU463L Air Cargo Pallet specifications. Maximum Contact Pressure less than 50 PSI. Creates 7.0-degree load angle or less on C5 and C17 aircraft. Ramps must have adjustable stands with a maximum stand of 36 inch height. Ramps must include a shipping container where all pieces fit. Ramp set up must have a single wheel width of 36 inches. Ramps must comply with concentrated load aircraft limitations. All ramp components must have been verified by ATTLA and listed on the Internal Air Transport Certification to meet requirements for loading onto C-130, C-17, C-5, and Landing Craft Air Cushion. Must provide a minimum limited warranty of two (2) years on ramp system. Must provide a minimum limited warranty of one (1) year on storage box. ATTLA Certification is required for Ramp System to be employed. Offeror shall provide evidence of certification. Brand Name or Equal similar to following characteristics: All ramps 36 wide. Outside Runs 4 spacing between each 2 wide heavy duty serrated cleat. (5 teeth per cleat minimum). Inside Run 2 spacing between each 2 wide heavy duty serrated cleat. (5 teeth per cleat minimum). Approach Ramp. 100 long. Approx. 135 lbs. each. 2 handles on each side. Qty = 3 needed Main Ramp. 94 long. Approx. 151 lbs. each. 2 handles on each side. Qty = 3 needed Door Wedge Ramp. 44 long. Approx. 71 lbs. each. 1 handle on each side of ramp. Qty = 3 needed 10 tall center support stands. Approx. 25 lbs. each. Qty = 3 needed. Industrial belting adhered to any place that system component touches the aircraft to prevent ramp movement on aircraft. This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. Prospective awardees must be registered in System for Award Management (SAMs) prior to invoicing. Information on registering in SAMs may be obtained at https://www.sam.gov. The provisions FAR 52.212-1 Instruction to Offerors - Commercial Items and FAR 52.212-3 Offeror Representations and Certifications- Commercial Items apply to this acquisition. The clause FAR 52.212-4 Contract Terms and Conditions - Commercial Items and 52.212-5 Contract Terms and Conditions Required To Implement Statutes Or Executive Orders - Commercial Items apply to this acquisition. The contractor shall comply with all Federal, State, and Local regulations. Please refer to attachments for RFQ and evaluation criteria. Place of delivery, Camp Arifjan, Kuwait.