CGC BLACKTIP DD FY17

SOURCES SOUGHT NOTICE: DRYDOCK REPAIRS USCGC BLACKTIP (WPB-87326) This is a SOURCES SOUGHT NOTICE / REQUEST FOR INFORMATION; not a pre-solicitation notice or solicitation for proposals/quotations. Pursuant to FAR Part 10 (Market Research), the purpose of this notice is to: (1) determine if sources capable of satisfying the agency's requirements exists, (2) determine if commercial items suitable to meet the agency's needs are available or could be modified to meet the agency's requirements, and (3) determine the commercial practices of company's engaged in providing the needed service or supply. Pursuant to FAR Part 6 and FAR Part 19, competition and set-aside decisions may be based on the results of this market research. This notice in no way obligates the Government to any further action. REQUIREMENT: This notice is issued by the U.S. Coast Guard, Surface Forces Logistics Center, Norfolk, VA to identify sources capable of providing the following: DRYDOCK Repairs Specification: (Subject to change at the discretion of the Government)Contractor shall provide all necessary materials, equipment, and personnel to perform DRYDOCK repairs to the U.S. Coast Guard Cutter (USCGC) BLACKTIP (WPB-87326), an 87 Foot Patrol Boat. The vessel is home ported in 4201 Victoria Avenue, Oxnard, CA 31328. All work will be performed at the vessel's home port. (There is a GEO restriction on this availability. This vessel is restricted to San Francisco Bay and South) Scope of Work: The scope of the acquisition is for DRYDOCK repairs of the USCGC BLACKTIP (WPB-87326). This work will include, but is not limited to the following work items: WORK ITEM 1: Hull Plating (Side Scan), Ultrasonic Testing WORK ITEM 2: Ultrasonic Thickness Measurements, Perform WORK ITEM 3: Hull Plating (U/W Body), Inspect WORK ITEM 4: Bilge Surfaces (Lazarette), Preserve ("Partial") WORK ITEM 5: Bilge Surfaces (Engine Room), Preserve ("Partial") WORK ITEM 6: Dirty Oil Tank, Clean and Inspect WORK ITEM 7: Oily Water Tank, Clean and Inspect WORK ITEM 8: Voids (Non-Accessible), Internal Surfaces, Preserve WORK ITEM 9: Tanks (MP Fuel Service), Clean and Inspect WORK ITEM 10: Oily Water Tank, Preserve WORK ITEM 11: Decks - Exterior (Main Deck), Preserve WORK ITEM 12: Pilothouse Deck (Aluminum), Repair WORK ITEM 13: Depth Sounder, Capastic Fairing, Renew WORK ITEM 14: Main Engine/Reduction Gear, Realign WORK ITEM 15: Propulsion Shafts, Remove, Inspect and Reinstall WORK ITEM 16: Propulsion Shaft, Repair WORK ITEM 17: Propulsion Shaft, Straighten WORK ITEM 18: Intermediate Water-Lubricated Propulsion Shaft Bearing, Renew WORK ITEM 19: Aft Water-Lubricated Propulsion Shaft Bearing, Renew WORK ITEM 20: Intermediate Bearing Carrier, Renew WORK ITEM 21: Aft Bearing Carrier, Renew WORK ITEM 22: Stern Tubes, Interior Surfaces, Preserve 100% WORK ITEM 23: Stern Tubes, Interior Surfaces, Repair WORK ITEM 24: Propellers, Remove, Inspect, and Reinstall WORK ITEM 25: Fathometer Transducer, Renew WORK ITEM 26: Underwater (Speed) Log Transducer(s), Renew WORK ITEM 27: Speed Log, Skin Valve Assembly, Clean and Inspect WORK ITEM 28: Sea Valves and Waster Pieces, Overhaul or Renew WORK ITEM 29: Sea Strainers (All Sizes), Renew WORK ITEM 30: Sea Strainers - Simplex (All Sizes), Clean and Inspect WORK ITEM 31: Rudder Assemblies, Remove, Inspect and Reinstall WORK ITEM 32: DELETED WORK ITEM 33: RHIB Notch Skid Pads, Inspect WORK ITEM 34: RHIB Notch Skid Pad Stud(s), Renew WORK ITEM 35: Forward RHIB Notch Skid Pad Stud, Remove, Inspect, and Reinstall WORK ITEM 36: Stern Launch Door, Remove, Inspect and Reinstall WORK ITEM 37: Grey Water Holding Tank(s), Clean and Inspect WORK ITEM 38: Sewage Holding Tank(s), Clean and Inspect WORK ITEM 39: Grey Water Piping, Clean and Flush WORK ITEM 40: Sewage Piping, Clean And Flush WORK ITEM 41: Joiner Bulkhead Panels, Renew WORK ITEM 42: Forward Peak Compartment, Preserve WORK ITEM 43: U/W Body, Preserve (100%) WORK ITEM 44: Hull Plating Freeboard, Preserve "100%" WORK ITEM 45: Main Mast, Preserve, 100% WORK ITEM 46: Superstructure, Preserve "100%" WORK ITEM 47: Cathodic Protection / Zinc Anodes, Renew WORK ITEM 48: Drydock WORK ITEM 49: Temporary Services, Provide - Cutter WORK ITEM 50: Sea Trial Performance, Support, Provide WORK ITEM 51: Ventilation Systems, Commercial Clean WORK ITEM 52: Deck Covering (Interior Wet/Dry), Renew WORK ITEM 53: Deck Covering, Carpeting, Renew WORK ITEM 54: Pilothouse Deck Covering System, Inspect and Renew WORK ITEM 55: Mast Wire Run Standoffs, Renew All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. Anticipated Period of Performance: The period of performance is anticipated to be Fifty-five (55) calendar days with a start date of 10 March 2017 and end date of 03 May 2017. (Subject to change at the discretion of the Government) Anticipated NAICS Code/Size Standard: The applicable NAICS Code is 336611, Ship Building and Repairing and the size standard is 1,250 employees. Submission of Information: Companies having capabilities necessary to meet or exceed the stated requirements are invited to provide information to contribute to this market survey/sources sought notice including commercial market information and company information. Companies may respond to this Sources Sought Notice via e-mail to contact@example.gov no later than 10:00 AM Eastern Standard Time on 09 December 2016 with the following information/documentation: 1. Name of Company, Address and DUNS Number. 2. Point of Contact and Phone Number. 3. Business Size applicable to the NAICS Code: 8(a) Small Business Concern; b. HubZone Small Business Concern; c. Service-Disabled Veteran Owned Small Business Concern (SDVOSBC); d. Veteran Owned Small Business Concern (VOSBC); e. ED Woman Owned Small Business Concern (EDWOSB); f. Woman Owned Small Business Concern (WOSBC); g. Small Business Concern; h. Large Business Concern 4. Documentation Verifying Small Business Certification: a. If claiming 8(a) status, provide a copy of your 8(a) Certificate from SBA. b. If claiming HUBZone status, provide a copy of your HUBZone Certificate from SBA. c. If claiming SDVOSBC status, provide documentation that shows the Service Disable Veteran (SDV) unconditionally owns 51 % of the business, controls the management and daily operations, and holds the highest officer position in the company. Documentation should also be provided to show that the SDV has a service-connected disability that has been determined by the Department of Defense or Department of Veteran Affairs. Finally, provide documentation that shows the business is small under the NAICS code 336611. d. If claiming VOSBC status, provide documentation that shows the Veteran unconditionally owns 51% of the business, controls the management and daily operation, make long-term decisions for the business, and holds the highest officer position in the company that works at the business fulltime during normal working hours. The documentation should also show the business is small under the NAICS code 336611. e. If claiming EDWOSB status, provide documentation that shows the company is at least 51% owned by one or more women who are "economically disadvantaged", and primarily managed by an economically disadvantaged woman that make long-term decisions for the business, hold the highest officer position in the business and work at the business full-time during normal working hours. The documentation should also show the business is small under the NAICS code 336611. A woman is presumed economically disadvantaged if she has a personal net worth of less than $750,000 (with some exclusions), her adjusted gross yearly income averaged over the three years preceding the certification less than $350,000, and the fair market value of all her assets is less than $6 million f. If claiming Woman Owned Small Business status, provide documentation that shows the company is at least 51% owned and controlled by one or more women, and primarily managed by one or more women that make long-term decisions for the business and hold the highest officer position in the business and work at the business full time during normal working hours. The women must be U.S. citizens. The documentation should also show the business is small under the NAICS code 336611. g. If claiming Small Business status, provide documentation to show the business is small under NAICS code 336611. 5. Statement of Proposal Submission: Statement on how your company will do the work and that your company WILL submit a proposal as a prime contractor if a solicitation is issued as a result of this Sources Sought Notice. 6. Past Performance Information: Evidence of experience in work similar in type and scope to include contract numbers, project titles, and dollar amounts, points of contact and telephone numbers. If two companies are planning to conduct business and submit an offer as a Joint Venture or similar type of teaming agreement, they are requested to provide past performance information on projects of similar scope that they have performed together as a Joint Venture, if available. Providing individual past performance documentation from each company on separate projects where the two did not work together may be considered less relevant. SAM: Interested parties should register at the System for Award Management (SAM) website as prescribed in FAR Clause 52.204-99(August 2012)(Deviation). SAM can be obtained by accessing the internet at www.csam.gov or by calling +1 (555) 000-0000. Disclaimer and Important Notes: This Sources Sought Notice is for market research purposes only and does not constitute a Request for Proposal/Quotation; and, it is not considered to be a commitment by the Government to award a contract nor will the Government pay for any information provided; no basis for claim against the Government shall arise as a result from a response to this Sources Sought Notice or Government use of any information provided. Failure to respond or submit information in sufficient detail may result in a company not being considered a likely offeror when making a decision on whether or how to set aside a solicitation for restricted competition. Regardless of the information obtained from this Sources Sought Notice, the Government reserves the right to consider any arrangement as deemed appropriated for this requirement. Respondents are advised that the Government is under no obligation to acknowledge receipt of the information received or provide feedback to respondents with respect to any information submitted. No proprietary, classified, confidential, or sensitive information should be included in your response to this Sources Sought Notice. The Government reserves the right to use any information provided by respondents for any purpose deemed necessary and legally appropriate, including using technical information provided by respondents in any resultant solicitation. At this time no solicitation exists; therefore, Do Not Request a Copy of the Solicitation. After a review of the responses received, a pre-solicitation notice and solicitation may be published on Federal Business Opportunities (FedBizOpps) website. It is the potential offeror's responsibility to monitor FedBizOpps for release of any future solicitation that may result from this Sources Sought Notice. However, responses to this Sources Sought Notice will not be considered adequate responses to any resultant solicitation.