DRIVE ASSEMBLY, MAIN

DRIVE ASSEMBLY,MAIN
DRIVE ASSEMBLY, MAIN.
RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT:
http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx
FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE
THIS ITEM IS A "DEFENSE ARTICLE" AS DEFINED IN AND SUBJECT TO THE INTERNATIONAL TRAFFIC IN ARMS REGULATIONS (22 C.F.R. 120-30) AND THE ARMS EXPORT CONTROL ACT (22 U.S.C.A. 2778-2799). ANY MANUFACTURER OR EXPORTER OF DEFENSE ARTICLES IS REQUIRED TO REGISTER WITH THE DIRECTORATE OF DEFENSE TRADE CONTROLS (DDTC), DEPARTMENT OF STATE. DOCUMENTARY EVIDENCE OF REGISTRATION MAY BE REQUIRED PRIOR TO AWARD. ADDITIONAL EXPORT RESTRICTIONS APPLY AS INDICATED HEREIN. FAILURE TO SUBMIT DDTC REGISTRATION WHEN REQUESTED WILL MAKE A QUOTE/OFFER INELIGIBLE FOR AWARD
______________EXCEPTION DATA___________________
IF DRAWING NOTE GIVES OPTION FOR ZINC OR MANGANESE COATING THEN MANGANESE IS REQUIRED.
DRAWING 200415485 NOTES 1, 3, 4, AND 12 APPLY.
____________END OF EXCEPTIONS_________________
THE ITEM BEING PROCURED IS A CRITICAL GUN PART ITEM WITH UNIQUE REQUIREMENTS.
GOVERNMENT FAT APPLIES.
AFTER RECEIPT OF QUOTES, OFFERORS MAY BE CONTACTED TO PRICE THE FAT REQUIREMENT.
THREE (3) EXHIBITS ARE REQUIRED: ONE (1) FULLY ASSEMBLED WITH COATING, TWO (2) NOT ASSEMBLED WITHOUT COATING.
DIMENSIONS APPLY PRIOR TO APPLICATION OF ALL COATINGS AND FINISHES.
THE CONTRACTOR SHALL MARK THE FIRST ARTICLE PACKAGING WITH "FOR DSCC ARMAMENT PROJECT" AND 2"RED LETTERING STATING "FIRST ARTICLE".
IN ADDITION, MANUFACTURE SHALL PROVIDE ALL CERTIFIED MASTER GEARS REQUIRED PER DRAWING 891C700 AND/OR SUB-DRAWINGS WITH THE FIRST ARTICLE EXHIBIT FOR USE IN VERIFYING GEAR DATA.
EXHIBIT DISPOSITION NSN/Part Number: 1005-01-062-6981 Quantity: 3 EA