Equipment Lean-To Concrete Pad and Lean-To Erection

Springville City Power is soliciting proposals for the engineering and construction of a rebar-reinforced 6-inch concrete pad and the erection of a pre-purchased 60' x 24' x 15'9" metal lean-to building. Located at the Electric Operations Center at 777 N. 425 W. in Springville, Utah, the project requires the contractor to handle all permitting through the city building department and ensure the slab-on-grade is sufficient for the weight of power equipment. All work must adhere to Shums Coda stamped plans and geotechnical recommendations, including a maximum net allowable bearing pressure of 1,500 psf and frost protection extending 30 inches below grade. The project must be completed and invoiced by June 30, 2027. Proposals are due by September 9, 2026, at 2:00 p.m. MDT via the Euna Supplier Network. Selection is based on a 100-point scale evaluating experience and qualifications (35 points), cost (35 points), project timeline (20 points), and submission completeness (10 points). Applicants must provide a Statement of Qualifications, a letter of introduction, and proof of an active Contractors 5501 license with B100/B200 endorsements. Awarded contractors must maintain comprehensive insurance, including $2 million per occurrence in general liability and $1 million in automobile liability, and are required to clean the site nightly while maintaining access to interior complex roads.