Fence Project at Ft. Bliss, Texas

03 August 2020 - Additional Questions and Answers added, Consolidated Q and A document. 31 July 2020 - Questions and Answers document posted. Questions submitted during site visit held on 30 July 2020. Driving directions to site visit location: https://www.google.com/maps/dir/Chaffee+Visitor+Control+Center,+Chaffee+Road Note: The time was corrected to read 2:00 PM (Mountain Time). To obtain a Post vehicle pass at the Chaffee Gate, Chaffee gate is located off of expressway 601 at exit 21. Must have a valid driver's license and proof of insurance to obtain a pass. For any concerns/issues obtaining a vehicle pass, please call MSgt Bobby Heath at (817) 793-3652. Site Visit is scheduled for 30 July 2020, 2:00 PM (MT). Please see the Q&A sheet for details to attend. See revised documents (4). Install new fencing, remove existing fencing and install manual sliding vehicle gates around building 720, LOGDET Compound, located at Ft. Bliss, Texas. Install approximately 734' of new 7' high chain link fencing with 1' triple-strand barbwire. Install two lockable 20' sliding vehicle gate and one 40' sliding vehicle gate, both 7' high with 1' triple-strand barb wire. Remove/repurpose a 260' section of 8' chain link fencing with triple strand barb wire. Install an approximately 7' corner section of 7' high chain link fencing with triple-strand barb wire connecting two existing sections of fencing. The first leg of this new corner section will extend approximately 200' SW along Merritt Rd from the current fence line adjacent to Holbrooks Rd (enclosing Bldg. 720). The second leg will turn 90 -degrees to the NW and run approximately 254' to the existing corner junction of fencing located directly north of Bldg. 717 (water tower). Install a 40' duel sliding vehicle gate (two 20' sliding sections) 7' high with 1' triple strand barb wire. Gate will be constructed along the existing section of fencing along Holbrooks Rd with the opening approximately 20' north of the fence junction located near intersection of Holbrooks and Merritt Rds. Install a 20' sliding vehicle gate 7' high with 1' triple strand barb wire NW to access building 720 loading and unloading area. Install a 20' sliding vehicle gate 7' high with 1' triple strand barb wire on the western side of the property adjacent to building 717 (water tower). Remove the approximately 260' section of existing 8' high fencing and 1 ft. triple strand barb wire located SW of Building 720. Pole removal and footing removed, hole must be filled with similar material to surrounding surface and level with existing grade.