Mechanical Repairs Bldg TT113 CDC

The contract solicitation N40085-26-R-9010 is a total small business set-aside under FAR 19.5 for mechanical repairs at Building TT113 at Camp Lejeune, North Carolina, with performance to be conducted on-site at that location. Awarded by NAVFAC Mid-Atlantic, the office is based in Norfolk, Virginia, and the primary point of contact is Clifton Gaither, with Lauren Loconto as the secondary contact. The NAICS code 236220 designates this as a commercial and institutional building construction project. Submissions must be made electronically through the eCMS portal by the specified deadlines, with hard copies permitted only in the event of system failure. The contract requires comprehensive submittals including shop drawings, quality control plans, material test reports, environmental documentation, welder qualifications, and safety certifications, all governed by standards such as ASTM, ICC IPC, NSF/ANSI, NFPA 70, and EM 385-1-1. The work involves strict compliance with environmental regulations, including the prohibition of hazardous materials like asbestos, lead, and hexavalent chromium, and mandates submission of SDSs and an Authorized Use List. All personnel must be registered in DBIDS, use PKI authentication for eCMS access, and meet qualification criteria including a superintendent with ten years of construction experience, five of which must be in a similar role. Work must be performed during standard hours from 0730 to 1600 Monday through Friday, with 48-hour advance notice required for excavation and 15-day advance notice for utility interruptions. Safety performance is monitored through metrics including a DART rate not exceeding 3.4 and an EMR of 1.10 or lower, with failure to submit required reports potentially triggering a 10% voucher retention. Packaging and marking requirements specify nameplates and tags with minimum 0.25-inch block lettering made of melamine plastic, die-stamped to 0.015-inch depth, and the use of buried warning tape per TIA-590. Corrosion protection must utilize hot-dip galvanizing per ASTM A123 or cadmium plating per ASTM B766, with prohibitions against direct aluminum-to-earth contact. Invoicing must be conducted via WAWF with a 2 MB attachment limit per invoice, and final acceptance inspections occur on-site with the Government holding