PLUG, LEFT

The contract pertains to the procurement of seven units of a PLUG, LEFT, identified by NSN 5365997234334 and part number 3A020-0215, sourced from IPECO HOLDINGS LTD, CAGE code K9075. The total contract value is $49.00, with delivery required within 144 days of award to the destination address at Arizona Industries for the Blind in Phoenix, AZ. The item must be delivered FOB origin, but inspection and acceptance occur at the destination, with zero tolerance for non-conformances under applicable sampling standards such as MIL-STD-1916 or ASQ H1331, where critical, major, and minor attributes are assigned verification levels VII, IV, and II or AQLs of 0.1, 1.0, and 4.0 respectively. All technical and quality requirements are governed by the DLA Master List of Technical and Quality Requirements, which supersedes other standards including ASTM D3951 for packaging, which itself must be followed unless overridden by DLA requirements. Marking and labeling must comply with MIL-STD-129, including standardized barcoding, and palletization must conform to RP001. The contractor is required to meet all federal compliance obligations, including employment eligibility verification, combating human trafficking, hazardous material identification, safeguarding covered defense information, and prohibited use of hexavalent chromium and covered defense telecommunications equipment. The contract mandates use of the Wide Area WorkFlow system for invoicing and references multiple FAR and DFARS clauses addressing contractual terms, subcontracting, whistleblower rights, and cybersecurity. The solicitation was issued on August 3, 2026, with a response deadline of August 11, 2026, under solicitation number SPE4A7-26-T-607A, and no options or indefinite-delivery terms are included. The acquisition falls under NAICS code 332510 and is processed through the Defense Logistics Agency via DIBBS. The offeror must provide valid UEI and CAGE codes, represent size status and socioeconomic program eligibility if applicable, and confirm compliance with all representations and certifications. No technical drawings or bidsets are available from DLA, and the contractor is responsible for full conformance with all specified standards and regulatory requirements.