SWITCH, THERMOSTATIC

The contract pertains to the procurement of two thermostatic switches, identified by NSN 5930015926435 and part number P/N 300622 from POLYAMP AKTIEBOLAG A163N, under solicitation SPE7M8-26-T-5426. Deliveries are to be made FOB origin to the designated receiving warehouse in Tracy, California, with an original required delivery date of October 14, 2026, and a need ship date of November 17, 2026. The quantity is fixed at two units with no variance allowed, and inspection and acceptance occur at the destination using the DLA-established procedures. Packaging must comply with either ASTM D3951 for non-hazardous materials or the more stringent TQ requirement IP025 for hazardous items, and all packaging and labeling must conform to MIL-STD-129, including barcoding and hazard markings where applicable. Palletization must follow DLA’s RP001 packaging requirements, and the DLA Master List of Technical and Quality Requirements takes precedence over commercial standards. Mercury and mercury-containing compounds are prohibited unless explicitly exempted for functional uses such as batteries, sensors, or specific instruments, and when present, portable mercury-containing devices must have shock-proof containment with a secondary barrier as per NAVSEA 5100-003D. The contract mandates compliance with a comprehensive set of FAR and DFARS clauses covering equal opportunity, trafficking prevention, cybersecurity, sustainable products, hazardous material handling, export controls, and safeguarding covered defense information. Electronic submission of invoices and receiving reports is required via WAWF, and the offeror must hold a valid UEI and CAGE code. Offerors must also complete representations regarding small business status, socioeconomic certifications, and potential provision of covered defense telecommunications equipment, with all information subject to verification. The contractor is responsible for ensuring all technical, quality, and safety standards are met prior to delivery, and any deviation from specifications may result in rejection at the point of inspection.