Tamiami Park - Pool Substrate Pump Room and Filtration System Renovation Rebid

(Contractor must obtain and submit all permits prior to performing any work.) CONTRACTOR shall review all documents, specifications, and scope of work provided by Miami-Dade County Parks, Recreation, and Open Spaces Department for work to be completed. Furnish all labor, equipment, and materials required to comply with the intent of the WORK described in the contract documents including but not limited to: Scope of work to remove all pool filter system to replace with new, all chlorine related system and replace with new, all c/o 2 system and replace with new, all pump room structures to be removed and replaced with new, all electrical panels to be replaced to match existing pending design changes and replace with new, pool substrate resurfacing, pool substrate coping replacement, pool ladder handrail removal and replacement, pool deck drain replacement, pool bldg. full view windows and door facing pool deck. Contractor shall remove existing and replace with PVC/aquatic mechanical rated products for all pool piping as required to meet current Florida building/DOH codes to include all ball, gate, butterfly, multiport, diverter, check valves, etc. All materials shall be noncorrosive as applies to use/location of item(s). Pipe Replacement (main drain, gutter/return lines, all filter components/piping from pool substrate to retention tank, valves, etc. Prior to submitting bid, the contractor is to visit site and become familiar with areas and requirements as per scope of work needed in RPQ and shop drawing provided by owner to complete project. Contractor shall be required to complete/responsible for onsite measurements as applies for submission per building code requirements for permitting (Aquatic calculated Required), contractor shall reference shop drawing, specifications by owner. Contractor shall furnish all documents to include sealed plan/drawings, calculations, manufactures specifications, detailing scope of work as required for permitting, all associated fees for design, plan processing and permitting cost will be reimbursed through dedicated allowance upon permit issued. Contractor shall reference owner shop drawings, specifications and documents to complete plans for permitting (Aquatic calculated Required). Contractor shall provide a representative for all manufactured products to determine the preparation and installation of all areas as applies in scope of work. Any imperfection’s workmanship detected by the manufacturer representative and/or owner shall be repaired prior to completion of project. Prior to submitting bid, contractor is to visit site and become familiar with areas and requirements as per scope of work needed in RPQ and shop drawings/attachments provided by owner to complete project as reference only. Contractor will be required to complete on site measurements as applies for submission per building code requirements for permitting as per shop drawing/attachments by owner as reference only.