USCG ANTHONY PETIT PETIT (WLM-558) DD FY24

***SEE ATTACHED FOR FULL TEXT NOTICE*** ***SEE ATTACHED FOR FULL TEXT NOTICE*** This is a SOURCES SOUGHT NOTICE / REQUEST FOR INFORMATION; not a pre-solicitation notice or solicitation for proposals/quotations. The applicable NAICS Code is 336611, Ship Building and Repairing, and the size standard is 1,250 employees. USCGC ANTHONY PETIT (WLM-558) DRY DOCK AVAILABILITY FY 24 REQUIREMENT: This notice is issued by the U.S. Coast Guard, Surface Forces Logistics Center, and Alameda, CA to identify sources capable of providing the following: Contractor shall provide all necessary labor, materials, services, equipment, supplies, power, accessories, special tools and such other things as are necessary to perform DRY DOCK maintenance to the U.S. Coast Guard Cutter, USCGC ANTHONY PETIT (WLM-558) a 175 Coastal Buoy Tender. This requirement is for a vessel that is homeported in Coast Guard District 17 (the State of Alaska). It is anticipated that this requirement will be solicited in accordance with Sec 8220 Alaska Shipyard Provision, SEC. 9210. VESSEL CONVERSION, ALTERATION, AND REPAIR PROJECTS. Sec 8220 Alaska Shipyard Provision SEC. 9210. VESSEL CONVERSION, ALTERATION, AND REPAIR PROJECTS. (a) IN GENERAL.Notwithstanding any provision of the Small Business Act (15 U.S.C. 631 et seq.) and any regulation or policy implementing such Act, the Commandant may use full and open competitive procedures, as prescribed in section 2304 of title 10, United States Code, to acquire maintenance and repair services for vessels with a homeport in Coast Guard District 17. (b) APPLICABILITY.Subsection (a) shall apply only if there are not at least 2 qualified small businesses located in Coast Guard District 17 that are able and available to provide the services described in such subsection. (c) LIMITATION.The full and open competitive procedures described in subsection (a) may only be used to acquire such services from a business located in Coast Guard District 17 that is able and available to provide such services. ANTICIPATED NAICS CODE/SIZE STANDARD: The applicable NAICS Code is 336611, Ship Building and Repairing and the size standard is 1,250 employees. Operational Limitations: Military considerations for CGC ANTHONY PETIT's FY24 Dry Dock location to be within the inside passages of Southeast, AK and the protected waters of the Pacific Northwest. This military consideration is requested due to potential safety concerns associated with commercial facilities outside the inside passages of Southeast, AK, and the protected waters of the Pacific Northwest. The Gulf of Alaska, as an example, regularly experiences sea states that exceed the operational and design limitations outlined in reference (a) for CGC ANTHONY PETIT. During the scheduled period of industrial performance, the Gulf of Alaska exceeds sea state four 52% of the time, per reference (b), thereby providing limited safe windows for the cutter to safely complete the 3-day transit across the Gulf of Alaska. Encountering sea states beyond the design limitations of the vessel could have a disastrous impact on the seaworthiness of the vessel placing the cutter crew's safety at risk. To safely cross the Gulf of Alaska, CGC ANTHONY PETIT would be required to wait for an acceptable forecasted sea state, which would jeopardize their ability to meet the scheduled contract start date or meet a reasonable delayed date. CGC ANTHONY PETIT services the aids to navigation that supports the safe usage of the US Navy's Southeast Alaska Acoustic Measurement Facility (SEAFAC), located in Behm Canal near Ketchikan, Alaska. SEAFAC supports submarine operations for the entire West Coast submarine fleet. Approval of this request would increase ANTHONY PETIT's availability for operations and enhance DoD's readiness posture. (a) Coast Guard Projected Operational Environment for the WLM 175 Keeper Class Coastal Buoy Tender, OPNAVINST F3501.364 / COMDTINST M3501.61 (b) Climatic Atlas, Volume 1, NAVAIR 50-1C-552 PLACE OF PERFORMANCE: Vendor's Facility DRY DOCK Availability DESCRIPTION OF WORK: Contractor shall provide all necessary labor, materials, services, equipment, supplies, power, accessories, special tools and such other things as are necessary to perform DRY DOCK maintenance to the U.S. Coast Guard Cutter. Description: work includes approximately, but is not limited to, 82 Work Items including: steel repair, tank cleaning and inspection, ventilation cleaning and inspection, servicing machinery, insulation replacement, steel preservation, and deck repair. The scope of the acquisition is overhaul, renew, and repair various items. D-001 Fire Prevention Requirements D-002 Hull Plating, U/W Body, Inspect D-003 Hull Plating, U/W Body, Ultrasonic Testing O-004 U/W Body, Preserve, 100 percent O-005 U/W Body, Preserve, Partial, Condition A O-006 U/W Body, Preserve, Partial, Condition B O-007 U/W Body, Preserve, Partial, Condition C O-008 Hull Plating Freeboard, Preserve, Partial O-009 Hull Plating Freeboard, Preserve, 100 Percent D-010 Appendages, U/W, Leak Test O-011 Appendages, U/W, Internal, Preserve D-012 Chain Lockers, Clean and Inspect D-013 Tanks, Potable Water, Clean and Inspect D-014 Tanks, Ballast, Clean and Inspect D-015 Tanks, Dirty Oil and Waste, Clean and Inspect D-016 Z-Drive Input Drive Shaft, Bearings Inspect D-017 Z-Drive Propulsion Unit, Renew, Drydock D-018 Ship Service Diesel Generator, SSDG, Exhaust Piping, Commercial Clean D-019 Fathometer Transducer, Renew D-020 Vent Ducts, Engine And Motor Room, All, Commercial Cleaning D-021 Vent Ducts, Galley and Pantry Room, All, Commercial Cleaning D-022 Vent Ducts, Laundry Exhaust, Commercial Cleaning D-023 Vent Ducts, All Other, Commercial Cleaning D-024 Sea Valves and Waster Pieces, Overhaul Or Renew O-025 Sea Strainers, All Sizes, Renew D-026 Sea Strainers, Duplex, All Sizes, Overhaul D-027 Sea Bay, Clean and Inspect O-028 Sea Bay, Preserve 100% D-029 Potable Water Pneumatic Tanks, Clean and Inspect D-030 Thruster Unit (General), Overhaul D-031 Hull Fittings (Weight Handling Rigging Hardware), Inspect and Test D-032 Anchor Chains and Ground Tackle, Inspect and Repair D-033 Hull Fittings (Mooring and Towing), Inspect and Test O-034 Chain Locker, Preserve, 100 Percent O-035 Superstructure, Preserve, Partial D-036 Cathodic Protection, Zinc Anodes, Renew, D-037 Drydock D-038 Temporary Services, Provide - Cutter D-039 Sea Trial Performance, Support, Provide D-040 ATON Tie-down, Install D-041 Oily Water Separator, Replace D-042 Crane Winch DCV, Replace D-043 Thruster Quick Disconnects (QDs), Install D-044 Pump Room, Deck, Partial Preserve D-045 Vents, Preserve and Closures, Renew D-046 Potable Water Deck Connection Piping, Renew D-047 Cargo Hatch, Repair D-048 Vent Space (01-50-0-Q), Deck, Preserve D-049 Cross Deck Winch Kickpipe, Renew D-050 Doppler Speed Log, Upgrade D-051 Directional Control Valve, Upgrade D-052 Sea Strainers, Simplex, All Sizes, Clean and Inspect O-053 Tanks, Ballast, Preserve, 100 Percent O-054 Tanks, Ballast, Preserve, Partial O-055 Tanks, Dirty Oil and Waste, Preserve, 100 Percent, O-056 Tanks, Dirty Oil and Waste, Preserve, Partial, O-057 Tanks, Potable Water Preserve, 100 Percent O-058 Tanks, Potable Water, Preserve, Partial, D-059 Independent NACE Inspector (Level 3), Provide D-060 Tenting, Provide D-061 Hydraulically Operated Cargo Hatch, Inspect and Service D-062 Hydraulic Chain Stoppers, Inspect And Service D-063 Hydraulic Crossdeck Winches, Inspect And Service D-064 Hydraulic Inhaul Winch, Inspect And Service D-065 Mechanical Chain Stoppers, Inspect and Service D-066 Anchor Windlass, Inspect And Service D-067 Towing Bitts, Chocks, and Fairleads, Inspect and Test D-068 Warping Capstan (Aft), Inspect and Service D-069 Single Point Davit, Disassemble and Inspect D-070 Buoy Crane, Inspect And Service D-071 Decks - Exterior, Preserve, Non-Skid Broadcast Grit System D-072 Decks - Exterior (Buoy or Construction Deck), Preserve 100% D-073 Point of Use Potable Water Filters, Install D-074 Flame Detectors, Replace D-075 Vent Duct Systems, Repair D-076 Z-drive Standby Hydraulic and LO Pumps, Overhaul D-077 Drainage Valve and Remote Valve Operator, Renew D-078 MDE & SSDG Exhaust Stack Insulation, Renew D-079 Fuel Oil Piping, Renew D-080 Bilge Pump, Overhaul D-081 Bilges, Preserve D-082 Hull and Structural Plating, General, 12.75 lbs. Steel Plate, Renew ANTICIPATED PERIOD OF PERFORMANCE: April 08, 2024 through July 8, 2024 (Subject to change at the discretion of the Government). If the company is unable to meet this period of performance, it is incumbent upon the company to propose an alternative 91 calendar day period of performance. SUBMISSION OF INFORMATION: Companies having capabilities necessary to meet or exceed the stated requirements are invited to provide information to contribute to this market survey/sources sought notice including commercial market information and company information. Companies may respond to this Sources Sought Notice via e-mail to POC listed in the Sam.Gov announcement with the following information/documentation: Jerrod Gonzales @ Jerrod.a.gonzales@uscg.gov and Erin Olenjack @ Erin.A.Olenjack@uscg.mil no later than 0800 PST October 31, 2023, with all of the following information/documentation: 1. Name of Company, Address and DUNS Number. 2. Point of Contact and Phone Number. 3. Business Size applicable to the NAICS Code: 8(a) Small Business Concern; b. HUBZone Small Business Concern; c. Service-Disabled Veteran Owned Small Business Concern (SDVOSBC); d. Veteran Owned Small Business Concern (VOSBC); e. ED Woman Owned Small Business Concern (EDWOSB); f. Woman Owned Small Business Concern (WOSBC); g. Small Business Concern; h. Large Business Concern 4. Documentation Verifying Small Business Certification: Please provide the following documentation as it applies to your company. a. If claiming 8(a) status, provide a copy of your 8(a) Certificate from SBA. b. If claiming HUBZone status, provide a copy of your HUBZone Certificate from SBA. c. If claiming SDVOSB status, provide documentation that shows the Service Disable Veteran (SDV) unconditionally owns 51 % of the business, controls the management and daily operations, and holds the highest officer position in the company. Documentation should also be provided to show that the SDV has a service-connected disability that has been determined by the Department of Defense or Department of Veteran Affairs. Finally, provide documentation that shows the business is small under the NAICS code 336611. d. If claiming VOSB status, provide documentation that shows the Veteran unconditionally owns 51% of the business, controls the management and daily operation, make long-term decisions for the business, and holds the highest officer position in the company that works at the business fulltime during normal working hours. The documentation should also show the business is small under the NAICS code 336611. e. If claiming EDWOSB status, provide documentation that shows the company is at least 51% owned by one or more women who are "economically disadvantaged", and primarily managed by an economically disadvantaged woman that make long-term decisions for the business, hold the highest officer position in the business and work at the business full-time during normal working hours. The documentation should also show the business is small under the NAICS code 336611. A woman is presumed economically disadvantaged if she has a personal net worth of less than $750,000 (with some exclusions), her adjusted gross yearly income averaged over the three years preceding the certification less than $350,000, and the fair market value of all her assets is less than $6 million. f. If claiming Woman Owned Small Business (WOSB) status, provide documentation that shows the company is at least 51% owned and controlled by one or more women, and primarily managed by one or more women that make long-term decisions for the business and hold the highest officer position in the business and work at the business full time during normal working hours. The women must be U.S. citizens. The documentation should also show the business is small under the NAICS code 336611. g. If claiming Small Business status, provide documentation to show the business is small under NAICS code 336611. 5. Statement of Proposal Submission: Statement that your company WILL submit a proposal as a prime contractor if a solicitation is issued as a result of this Sources Sought Notice. 6. Past Performance Information: Evidence of experience in work similar in type and scope to include contract numbers, project titles, and dollar amounts, points of contact and telephone numbers. If two companies are planning to conduct business and submit an offer as a Joint Venture or similar type of teaming agreement, they are requested to provide past performance information on projects of similar scope that they have performed together as a Joint Venture, if available. Providing individual past performance documentation from each company on separate projects where the two did not work together may be considered less relevant. SAM: Interested parties should register at the System for Award Management (SAM) website as prescribed in FAR Clause 52.204-7 System for Award Management (OCT 2018). SAM can be obtained by accessing the internet at https://www.sam.gov/SAM/ or by calling 1-866-606-8220. Disclaimer and Important Notes: This Sources Sought Notice is for market research purposes only and does not constitute a Request for Proposal/Quotation; and, it is not considered to be a commitment by the Government to award a contract nor will the Government pay for any information provided; no basis for claim against the Government shall arise as a result from a response to this Sources Sought Notice or Government use of any information provided. Failure to respond or submit information in sufficient detail may result in a company not being considered a likely offeror when making a decision on whether or how to set aside a solicitation for restricted competition.