VME Test Station

Solicitation N00421-16-T-0029 is issued as a synopsis/solicitation. The Government intends to purchase on a firm fixed-price basis and to solicit and negotiate the proposed purchase order on a brand name basis under the authority of FAR 52.211-6, under the authority of FAR Part 12, FAR Part 13. This requirement is reserved for only Small Business responses. Offerors must be registered in the System for Award Management and have an active Cage Code when furnishing a quote This may be accomplished electronically by doing an internet search of System for Award Management (https://www.sam.gov) Alternate or Substituted items will not be accepted. Product Description: The hardware requested by this solicitation includes a Processor board, a transition module, a support package for when we load the operating system on it, and a rack mount enclosure to put it all in. This is all COTS equipment. The operating system (VX-Works) must be purchased separately because it is only sold by 1 vendor, and that vendor does not sell hardware; this will happen on a different contracts package. - 1) Items to be purchased: 4 items as follows: - i) 1 of P/N: 1C102L-A170000-00, Single Processor 7448 board @ 1 GHz, 512M: This includes SDRAM, 128 M Total Boot FLASH, 256 Protocol High Speed Serial Ports M Total User FLASH, 128 kB NVRAM, NO FLASH FILE, NO SSD, Two 1000 Base-T Ethernet Ports, Two 10/100 Base-T Ethernet Ports, Two USB 2.0 Ports, NO 1553B Port, Six Multi-Supporting RS-232/422/485, Two Standard UART Serial Ports supporting RS-232/422/485, 16 Single Ended TTL or 8 Differential RS-422 Discrete IO Lines, One Serial ATA Channel and Dual PMC sites - 64-bit 66 MHz. Lab, Air Cooled, 0oC to +55oC - ii) 1 of P/N: TM102-11-00, Transition Module for the C102 VME SBC Rear Plug-in Unit, Single Slot - iii) 1 of P/N BSP102-VXW-PPC, C102 VxWorks Board Support Package.This includes libraries and drivers for all on-board resources. Run-Time License should be procured directly from Wind River. Note: USB stack should be purchased directly from Wind River. - iv) 1 of P/N 11-1013801-10, Series RME-3813 VME64x Rack Mount Enclosure, Includes 5-slot, horizontal mount 6Ux160mm VME64x card cage with IEEE1101.10 front, 5-slot monolithic J1JOJ2 VME64x backplane,featuring 5mm-tail, 160pin, DIN inject/eject rails, keyed card guides, ESD stripping for EMI suppression connectors on J1; 17mmtail, 160pin, DIN connectors w/shrouds on J2; 2mm, hard-metric connectors w/shrouds on J0; on-board termination, with optional capacitors; Electronic BUSGRANT/IACK (EBG) 90-264VAC, 47-67Hz, +5V @ 30A, +3.3V @ 20A, +12V @ 16A, -12V @ 0.8A -total power not-to- exceed 300W; Four DC fans provide aggressive front-to-rear air flow; 300W power supply (Dawn p/n: 50-1012733-300, or equivalent), autoselect, Internal mounting provision for disk drive; 3-slot, rear direct plug-in transition module card cage (6Ux80mm); Rack mount 3U enclosure with 1" IEC rack mount flanges; Without RuSHTM; Includes Drive Bay/Carrier MRK- 515ST + the SATA cabling. Fully Assembled, Wired and TestED. - 2) Delivery: We are requesting that all hardware be delivered to the following address: Patuxent River, MD 20670 Full delivery address and Technical Point of Contact will be furnished at time of award.