Wharf Repairs - St. Lewis, Newfoundland & Labrador (NL)

Wharf Repairs St. Lewis, NL P/N: C2-00589 The scope of work for this project consists of the furnishing of all plant, labour, equipment and material for wharf repairs at St. Lewis, NL, in strict accordance with specifications and accompanying drawings and subject to all terms and conditions of the Contract. In general, the work under this contract consists of, but will not necessarily be limited to, the following: .1 Partial or total demolition and removal of required components. .2 Removal and replacement of the existing wheel guard and wheel guard blocking. .3 Removal and replacement of existing top horizontal hardwood fender. .4 Remove existing electrical trench concrete and replace with new. .5 Repair existing concrete deck. .6 Remove existing aluminum electrical pedestal and replace with a galvanized electrical pedestal that is currently on site. .7 Remove two (2) existing light fixtures from the existing jib crane and turn over to owner. Supply and install two (2) LED solar light fixtures on the existing jib crane. .8 Refurbish existing Type A and Type Bl mooring cleat anchor blocks. .9 Supply and install new mooring rings. .10 Remove and dispose of 13 existing bollards including removal of existing material from around existing waste oil tank foundation. .11 Supply and install 13 new bollards and new Type 1 material around existing waste oil tank foundation. .12 Removal and disposal of existing slipway hardwood runners, pressure treated sleepers and beams. .13 Removal and disposal of 1 existing winch house including concrete foundation and support blocks. .14 Removal and disposal of existing concrete winch cable blocks. .15 Supply and placement of new rock fill and granular materials for the new upland area. FAMILIARIZATION WITH SITE Before submitting a bid, bidders can visit the site and its surroundings, at their own expense and schedule, to review and verify the form, nature, and extent of the work, materials needed for the completion of the work, the means of access to the site, site remoteness, severity, exposure, and uncertainty of weather, soil conditions, any accommodations they may require, and in general shall obtain all necessary information as to risks, contingencies, and other circumstances which may influence or affect their bid. No allowance shall be made subsequently in this connection on account or error or negligence to properly observe and determine the conditions that will apply. Contractors, bidders, or those they invite to site are to review specification Section 01 35 28 – Health and Safety Requirements before visiting site. Take all appropriate safety measures for any visit to site, either before or after acceptance of bid. The Contractor must perform and complete the Work by March 31, 2024.