28 Blade, Turbine Rotor

The solicitation SPRMM1-26-Q-HB64 seeks the manufacture of a 28-blade turbine rotor under a Lowest Price Technically Acceptable (LPTA) evaluation framework, where technical acceptability is determined first and award is made to the lowest-priced offer that meets all requirements. The item, identified by NSN 014578173, must be produced according to the design specification under Cage Code 07482 L47574P01 and comply rigorously with military packaging, marking, and preservation standards including MIL-STD-2073-1, MIL-STD-129, and MIL-STD-130 Rev N, including mandatory Unique Item Identification (UII) marked via machine-readable formats per ISO/IEC 15434 and ANSI MH 10.8.2. Packaging must use only Qualified Products List (QPL)-approved materials and conform to specific levels based on shipment type—Level B for domestic and air-transported overseas shipments and Level A for surface overseas shipments—with nonstandard commercial pallets prohibited and only MH1-2016 Part No. MH1/9-07SW4848 pallets permitted. Wood packaging must meet ISPM 15 standards and bear the ALSC-approved mark. ESD-sensitive components require ANSI/ESD S20.20-2021 compliance, and hazardous materials are subject to 49 CFR regulations. All deliveries must achieve at least 85% remaining shelf life upon receipt as per Navy requirements. The contract mandates electronic submission of all invoices and receiving reports through WAWF, with payment processed via Electronic Funds Transfer, and all contractors must maintain active and accurate registrations in the System for Award Management (SAM). Key clauses impose compliance with whistleblower protections, prohibitions against subcontracting with debarred or suspended entities, and restrictions on sourcing materials from sanctioned regions including Venezuela, Xinjiang, and Russian fossil fuel operations. Cybersecurity obligations require adherence to NIST SP 800-171 and mandatory reporting of incidents under DFARS clauses. The contractor must immediately notify the contracting officer of any material obsolescence or production disruptions and obtain prior written approval for any variances or design changes. Inspection and acceptance may occur at origin or destination, with the contractor responsible for all inspection activities unless otherwise directed. No contract value has been specified in the solicitation as pricing data remains un