Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, November 11 at 2:00 PM ET

Register Free →

38--Excavator Accessories

Active
801817Q479Federal

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

AI Contract Overview

Show more

The U.S. Fish and Wildlife Service is soliciting quotes for a 3000 foot pound hammer and a manual thumb compatible with CASE Model 1088 and/or CASE Model 9030B excavators. This procurement, issued under solicitation number 801817Q479 as a Request for Quotes (RFQ), is a total small business set-aside and follows Federal Acquisition Regulation guidelines. Key deliverables include the hammer with an adapter bracket and dual edge chisel point, an additional blunt chisel point, the manual thumb with an extra base plate, a one-year warranty, labor and parts installation, and transportation of two excavators. The project requires delivery to the San Luis National Wildlife Refuge in Los Banos, California by November 30, 2007, with inspection and acceptance conducted on-site by Fish and Wildlife Service personnel. Quotes must be submitted by close of business on August 28, 2007, via email or mail to the designated contracting officer. Evaluation will prioritize technical compliance with the minimum salient features over cost, reflecting the importance of performance and specifications. Interested vendors must be registered in the Central Contractor Registration (CCR) system. The solicitation document incorporates standard commercial acquisition provisions and clauses, and further information or assistance can be obtained through the provided contacts and official electronic acquisition systems. This notice represents the sole solicitation for this procurement, with no subsequent postings anticipated.

General Info

Small business RFQ for 3000 lb hammer and thumb for CASE excavators, delivery by Nov 30, 2007.

NAICS

811310 - Commercial and Industrial Machinery and Equipment (except Automotive and Electronic) Repair and Maintenance

Place of Performance

VA

Set-Aside

SBA

Documents

0

No documents available

Documents will appear here when they are available.

AI Contract Breakdown

Uniform Contract Format

No documents to break down

The breakdown needs solicitation documents. None were found from this contract's source.

Timeline

PhasePresolicitation
Posted

Presolicitation

Ready to pursue this opportunity?

Get full access to track this contract, build proposals with AI assistance, and manage your pipeline.

Organization & Contact Information

Show more
AgencyDepartment Of The Interior → Fws Headquarters
ContactsNo contacts available
OfficeFALLS CHURCH, VA, 22041, USA
Office AddressFALLS CHURCH, VA, 22041, USA
ContactsNo contact information available

Full Description

Show more
This is a combined synopsis/solicitation from the U.S. Fish and Wildlife Service for a 3000 foot pound hammer and a manual thumb to accommodate a CASE Model 1088 and/or a CASE model 9030B, prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; quotes are being requested and a written solicitation will not be issued. The solicitation number is 801817Q479 and is issued as a Request for Quotes (RFQ). RFQ 801817Q479 may be viewed thru a link to the National Business Center Interior Electronic Acquisition System-Electronic Commerce at "http://www.fedbizopps.gov" or "http://www.nbc.gov". For assistance in downloading information from the National Business Center contact the helpdesk at +1 (555) 000-0000.No further notice will be posted on Fedbizopps. The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 05-18. This is a Set Aside for Small Business. The NAICS is 811310. The small business size standard is 6.5 million. This RFQ will be awarded upon best value. GENERAL: 1) 3000 foot pound hammer to accommodate a CASE Model 1088 and/or CASE Model 9030B to include adapter bracket/coupler with dual edge chisel point. 2) Additional blunt chisel point. 3) Manual thumb to accommodate a CASE Model 1088 and/or CASE Model 9030B to include additional base plate (2). 4) 1-Year Warranty 5) Labor and Parts installation 6) Transportation of 2 excavators PLACE/DELIVERY AND PERIOD OF PERFORMANCE: San Luis National Wildlife Refuge 7985 S Wolfsen Rd Los Banos, CA 93635-2176 The telephone number +1 (555) 000-0000. Delivery date is by November 30, 2007. INSPECTION AND ACCEPTANCE: At San Luis National Wildlife Refuge and will be subject to observation and inspection by U.S Fish and Wildlife Service personnel. . TECHNICAL COORDINATOR: Karl Stromayer at +1 (555) 000-0000 or email at contact@example.gov. Federal Acquisition Provision 52.212-1, Instructions to Offerors-Commercial, applies to this acquisition. Federal Acquisition Provision 52.212-2, Evaluation-Commercial Items, is included in this solicitation and the evaluation criteria, listed in descending order of importance are 1) Minimum salient features listed, and 2) Cost. All evaluation factors other than cost or price, when combined are significantly more important than cost or price. Offerors are to include a completed copy of the provision at 52.212-3, Offeror Representations and Certifications-Commercial Items, with its offer. This provision can be obtained from the following web site: http://www.arnet.gov/far/ . Federal Acquisition clause at 52.212-4, Contract Terms and Conditions-Commercial Items, applies to this acquisition. Federal Acquisition Regulation clause at 52.212-5, Contract Terms and Conditions Required To Implement Statutes or Executive Orders-Commercial Items, applies to this acquisition and includes applicable clauses under the simplified threshold. This announcement constitutes the only solicitation. Quotes can be emailed to the following: contact@example.gov. Written quotes must be received no later than COB August 28, 2007 and can be mailed to U.S. Fish and Wildlife Service, Contracting and General Services, 911 N.E. 11th Avenue, Portland Oregon 97232-4181, Attn: Jackie Merriman, Contracting Officer. Interested contractors must be registered in the CCR.

Similar Contracts

Same NAICS industry code

NAICS: 811310
New
Kubota M8200 Clutch Replacement
Solicitation # kubota-m8200-clutch-replacement
Management & Training Corporation (MTC) is soliciting bids for the clutch replacement of a Kubota M8200 tractor with front wheel assist, no cab or loader, located at the Earle C. Clements Job Corps Center in Morganfield, Kentucky. The scope of work requires the contractor to provide all transportation, labor, supervision, tools, and new manufacturer-specified parts to diagnose and repair the clutch assembly and power take-off (PTO) system. Key technical requirements include disassembling tractor components, replacing friction discs, bearings, oil seals, and O-rings, resurfacing the flywheel, and replacing hydraulic pipes and filters as necessary. The project is complete once the Facility Maintenance Department verifies proper clutch engagement and PTO operation under load. This is a small business set-aside opportunity under NAICS code 811310, open to various SBA-certified categories including VOSB, SDVOSB, WOSB, and HUBZone businesses. Proposals must be submitted via email to Angie Mahoney by November 3, 2026, and must include a lump sum bid sheet, a completed supplier packet with a W-9 and self-certification form, and proof of insurance. Award will be based on best value, considering the contractor's qualifications, experience, and the itemized cost breakdown. The contract is subject to Federal Acquisition Regulation (FAR) clauses regarding the Buy American Act, combating trafficking in persons, and Service Contract Labor Standards per Wage Determination No. 2015-4687 Revision 31 for Kentucky.
Earle C. Clements Job Corps Center

POSTED

about 5 hours ago

DEADLINE

in 5 days
View Details
NAICS: 811310
New
SLED
**Certified SB/DVBE Only** IFPQ Boiler Inspection, Maintenance, Repair, Testing, and Reporting in Los Angeles County
Solicitation # 07A6539
The California Department of Transportation (Caltrans) is soliciting price quotes for an Invitation for Price Quote (IFPQ 07A6539) to provide comprehensive boiler inspection, maintenance, repair, testing, and reporting services at the District 7 Office facility in Los Angeles, California. The scope of work includes annual and quarterly preventative maintenance for three Unilux water tube boilers and six boiler pumps, ensuring compliance with manufacturer standards, ASME Code, OSHA requirements, and South Coast Air Quality Management District standards. This is a set-aside solicitation exclusively for certified Small Business (SB), Microbusiness (MB), or Disabled Veteran Business Enterprise (DVBE) entities. The contract will be awarded to the responsible bidder offering the lowest price quote who meets all specifications. Key operational requirements include a 48-hour response time for routine service requests and a strict prohibition on subcontracting any portion of the work. The contractor must adhere to State General Prevailing Wage Rates for Los Angeles County and provide a payment bond for any service request exceeding 25,000 dollars. Required submission documents include a Price Quote Proposal, Bidder Certification Sheet, Non-Collusion Declaration, and certifications for California Civil Rights Laws and the Darfur Contracting Act. Invoicing is conducted monthly in arrears and must be accompanied by certified payroll records and DVBE utilization reports. The agreement is subject to a budget contingency clause, meaning it is enforceable only if sufficient funds are provided by the California State Legislature or the United States Government.
California Department of Transportation

POSTED

about 6 hours ago

DEADLINE

in 15 days
View Details
NAICS: 811310
New
SLED
RFP 07-135 Roseville Electric Utility – Air Compressor Maintenance
Solicitation # 07-135
The City of Roseville is soliciting proposals under RFP 07-135 for a consultant to provide comprehensive scheduled preventive and corrective maintenance for air compressors and auxiliary systems, including Ingersoll Rand equipment. The services will be performed at the Roseville Energy Park and Sunset Energy Center in California. The selected consultant will be responsible for providing all necessary labor, technical expertise, specialized tooling, and materials. This is a prevailing wage project with an initial contract duration of five years, estimated to commence in April or May. Proposals must be submitted by December 16, 2026, via email to the City Clerk or through physical delivery in a sealed container with the required Attachment H label. The award will be based on a formal evaluation panel process considering the firm's experience and qualifications (25 points), the proposed project plan (35 points), and cost (40 points), with potential interviews for top candidates. Requirements for the successful bidder include obtaining a City of Roseville business license, providing 100% faithful performance and labor and materials bonds, and maintaining specific insurance policies. Consultants must also disclose any conflicts of interest and adhere to the Levine Act regarding political contributions.
City of Roseville

POSTED

about 10 hours ago

DEADLINE

in about 2 months
View Details

Earlier notices in this NAICS code

Posted before this notice, open and closed

Ready to Pursue This Opportunity?

Get AI-powered intelligence on this solicitation and the ones like it

Every page of the solicitation package shredded into a compliance breakdown

AI-powered matching based on your capabilities and past performance

Competitor and incumbent history on the requirement

Automated alerts on amendments, Q&A deadlines, and award

Miguel
Hillary
Keith Deutsch
Christine

Join 750+ contractors already using CLEATUS