Double Arming Bolts

The contract specifies the procurement of Double Arming Bolts, also known as threaded double end rods, with exact dimensional requirements: one inch in diameter, fourteen inches in length, featuring five inches of threading on each end and cone-type points at both terminations. Each bolt must be supplied with four hex nuts pre-threaded onto the ends and manufactured from Grade A325 or A449 high strength steel, further protected by hot dipped galvanization compliant with ASTM A153 standards. Only approved manufacturers and part numbers are acceptable, including STLCTY1"X14"D. A. BOLT LA, NUT1814-GNP, ALLIEDB7983, HUGHESBA193B7-1014-5-2PL. The solicitation, identified by number Z4646, was posted on June 18, 2026, with responses due by June 23, 2026, and is issued by Nashville Electric Service under the Tennessee state agency designation. The place of performance is Nashville, Tennessee, and the primary point of contact for procurement inquiries is Tiffany Caruthers, reachable via email or phone provided.