Exterior Painting Of The City Of Murrieta Police Station

SCOPE OF WORKEXTERIOR PAINTING OF POLICE STATIONCITY PROJECT NO. 21016Project: Police Department – Exterior Painting of Police StationThe scope of work includes the repainting of the exterior of the City of Murrieta Police Department building, both main and support (approximately 28,391 square feet for main building and 6,943 square feet for support building; Contractor is responsible for their own measurement) located at 2 Town Square, Murrieta, CA, 92562 and various decorative items identified below. All exterior surfaces in this described area are included in this scope.Services to be Provided:SURFACE PREPARATION:• Surfaces not to be painted shall be protected during cleaning and painting operations.• When repairing areas of failed paint, bevel the edges of the intact existing paint so as to minimize the visual impact of the previous failure.• Clean and repair any crack, holes, and other surface imperfections• Surface must be clean and sound, free of chalk, peeling paint, efflorescence, oil, wax, grease, salts, dirt, and mildew.• Caulk all seams, cracks, and joints around doors, windows, siding, beams, flashing, etc. with Flexible Seal Urethane Caulking to produce watertight seal.• Ensure that expectations of humidity, precipitation and temperature during application and curing of paints are within the range permitted by the manufacturers. Record ambient conditions during application and curing and keep those records available for the owner and the paint manufacturer.PAINT PRODUCT• MANUFACTURERS A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering products that may be incorporated in the work include but are not limited to the following: 1. Dunn-Edwards. 2. Sherwin Williams. 3. approved substitution: B. PRIMERS 1. Exterior Primer Coating: Exterior alkyd wood primer for priming wood under alkyd gloss enamels, flat lusterless finish, and wood trim under medium shade or deep color high-gloss alkyds: 2. Synthetic, Rust-inhibiting Primer: Quick-drying, rust-inhibiting primer for priming ferrous metal on the exterior under full-gloss and flat alkyd enamel and on the interior under flat latex paint or odorless alkyd semi-gloss or alkyd gloss enamels: C. EXTERIOR FINISH PAINT MATERIAL (Primer plus at least two (2) coats.)1. Exterior Acrylic Emulsion; Quick-drying, flat, acrylic paint for use on the exterior over concrete, stucco, (including concrete masonry units). 2. Exterior Acrylic Emulsion: Quick-drying, flat, acrylic paint for use on the exterior over prime-coated wood and sealed and prime-coated painted plywood.3. Alkyd Gloss Enamel: Weather-resistant high-gloss enamel for use over primed ferrous metal surfaces:PAINT• Includes at least two coats of paint to cover all previously painted surfaces on the building which may include stucco, cement, wood, metal, doors, trim, gutters, flashing, surface mounted conduit, drain pipes, fascia, molding and sight screen.• City will provide color code on award of contract • Color correctness to be agreed upon in advance by both City and Contractor • Contractor shall follow all manufacturers’ instructions for application techniques and cure times• It is to be understood by the painting contractor that all coatings must conform to all state and local regulations at the time of application• The paint may not be adulterated by the addition of any substance without the manufacturer’s written consent and supervision• The contractor shall retain sufficient quantities of paint of the same batch until completion of the entire project to permit uniform touch-upWOOD: Prepare,stain and seal all exterior wood:• Scrape where needed• Sanding where needed• Filling gaps where needed• Apply primer as needed• Repair or replace wood as needed, then prepare and stain and seal DECORATIVE/ADDITIONAL ITEMS: Prepare and paint all decorative items:• Black metal accents• Hand rails• Rain gutters• Wind