ICDBG 2022 - $45,000.00
Contract Overview
Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.
AI Contract Overview
The Choctaw Nation Housing Authority is soliciting bids for a comprehensive renovation of a 1,280 square foot, 3-bedroom, 2-bathroom pier and beam frame home located in Heavener, Oklahoma. The project scope includes extensive interior and exterior upgrades, such as upgrading the electrical system to a 200-amp service, installing a new minimum 14.3 SEER2 rated gas HVAC unit, and replacing all windows with insulated vinyl low-E tilt sash units. Interior work involves full bathroom renovations with specific prohibitions on FRP surrounds, installing waterproof floating vinyl plank flooring, replacing drywall with purple board in wet areas, and blowing in attic insulation to achieve an R-Factor of 38. Exterior improvements include replacing back steps and deck boards with ground contact treated materials and installing smart siding. All work must meet or exceed the 2019 IRC, and the contractor is responsible for all permits, line locates, waste removal, and providing a storage container for the homeowner's contents. Bids must be itemized, include a price good date, and be submitted exclusively through the Housing Bid Board to be considered valid. This federally funded project is subject to Davis-Bacon Act labor standards and provides award preference to Indian organizations and Indian-owned economic enterprises. Prospective contractors are required to visit the site before bidding, as change orders for identifiable site conditions will not be approved. Payment for HVAC equipment requires the submission of an AHRI certificate with the invoice.
General Info
Place of Performance
Heavener, OK, 74937, USASet-Aside
Documents
1AI Contract Breakdown
Uniform Contract FormatSign up to view the full breakdown with detailed analysis of each section.
View Full BreakdownEverything you need to bid on this one
Open the full contract in your free workspace.
- 1 solicitation documentRead every page
- AI contract breakdown13 sections, Uniform Contract Format
- Buyer contactEmail and phone
Ask CLEATUS
I've read this contract. Ask me anything.
Timeline
Solicitation
Submission deadline
Response Deadline
Organization & Contact Information
Full Description
Special Instructions: Home is a 3-bed, 2-bath pier and beam frame home approx. 1280 sq. ft. All prospective contractors are required to visit the project site before submitting a bid. Change orders due to conditions that could have been identified during the site visit will not be considered or approved. Any questions, please contact. Case Manager- Jeannine Davis @ +1 (•••) •••-••••Sign up to see this detail Inspector- David Trowbridge @ +1 (•••) •••-••••Sign up to see this detail All work done must meet or exceed the 2019 IRC. All applicable licenses apply. It is highly recommended that contractors view the job before bidding. The contractor is responsible for all line locates and permits required. The contractor will be responsible for the cleanup and removal of all waste and restoring the yard to mowing conditions. The homeowner will select any/all colors used for the job. The contractor is responsible for all measurements and count of materials needed.
Drywall: Hall bathroom/master bedroom closet: Remove and replace all existing drywall, ceiling, and walls, down to studs, replace all deteriorated wood framing, including ceiling joists, etc. install new ½” purple board drywall, tape, bed, texture, to match new or existing finish. Repair or replace all damaged dry wall throughout the house, ceilings and walls, install new ½” drywall, tape, bed, texture, to match new or existing finish. TREAT THE EXPOSED WOOD FRAMING WITH VINEGAR.
Insulation: Remove all the attic insulation from the attic, Blow in approx. 12” of insulation to achieve a R-Factor of 38, in the attic. Insulate all the hall bathroom walls with a R-13 batt. insulation. Seal all plumbing penetrations throughout the house, using spray foam or caulking.
Plumbing: Bathroom Hall bathroom: Remove and replace tub/shower. remove and cover window. Install new tub/shower and surround, with Swan-Stone or comparable, must be a minimum of 1/4” thickness. Replace the shower handle and mixing valve with Delta or a comparable brand. Install new mixing valves throughout shower faucet FRP will not be accepted as a tub/shower surround. Remove and replace bathroom faucet, supply lines with shut-off valves and drain lines. Install Comfort height commode, wax ring, and supply and shut offs. Master bathroom: Remove and replace shower. remove and cover window and frame and insulate wall where needed Install new 5' low-entry shower base and surround, with Swan-Stone or comparable, must be a minimum of 1/4” thickness. Replace the shower handle and mixing valve with Delta or a comparable brand. FRP will not be accepted as a tub/shower surround. Repair/replace any all drywall, trim, sub and finish flooring, and paint needed due to repairs. This will include making all needed adjustments/replacement (framing, subflooring, drywall, moving plumbing, etc.) Remove the existing wall hung gas stove and cap off. NOTE: possibly cast-iron drains under home, contractor will be responsible for making all proper connections.
Flooring: Remove and replace all the subflooring in the hall bathroom and repair or replace damaged subflooring in master bathroom. Treat all exposed wood framing with vinegar before covering with new subflooring Remove existing floor covering throughout home, install new waterproof floating vinyl plank flooring with a minimum 3/16” thick flooring. Pull toilet and install flooring up to the floor flange. Install all new trim required for proper fit and finish. Participant will choose color.
Cabinets: Hall bathroom: Remove and replace the existing vanity with a min. 30" new vanity with top and sink. All vanities must have plywood bulkheads hardwood fronts and any necessary hardware required for proper smooth finish installation. Stain and seal/paint.
Mechanical-HVAC: Verify that all electrical components servicing the HVAC system-including wiring, breakers, panels and fuses-are properly grounded and compliant with all applicable codes. Any non-compliant conditions shall be corrected by the contractor. Including but not limited to installing any and all needed wiring, breakers, panels, and disconnects. Remove and replace the existing HVAC package unit. Install a new minimum 14.3 SEER2 rated energy efficient gas unit. Install new copper line-set, appropriate filter drier, thermostat, and registers. Caulk all ceiling drops to drywall before air register installation. Seal the return air cavity with drywall for energy efficiency. Replace the plenum if required for proper fitment of the new unit. If duct board is to be used for transition to plenum, all joints must be foil-taped, and an acrylic latex or mastic sealant is to be applied over foil-taped joints. New Ductwork that is to be installed or replaced under the home should be insulated metal pipe; flex duct is not to be used underneath the home. The contractor will be responsible for the proper sizing of the new unit. The contractor must provide the AHRI certificate for the equipment to be installed with the invoice for payment.
Doors: Remove and replace 1 side entry door. Install 1 pre-hung six-panel insulated metal door, install all trim required for proper fit and finish. Install new combination, keyed alike hardware, Kwikset or comparable. Caulk and seal inside and out. Paint to match new or existing finishes. Remove and replace the hall bathroom door, Install 1 new pre-hung interior doors, trim and hardware (Kwikset or comparable). paint to match new or existing finishes.
Electrical: Upgrade electrical to a 200-amp service (including incoming service if required). install new breaker box and breakers (label breaker panel), new wire throughout, receptacles, switches, fixtures, vent fans, and ceiling fans, (3 in Home). Repair all damage due to electrical change outs, to include but not limited to drywall, paint, paneling, flooring, and etc.
Painting: Prep all walls and ceilings, doors, trim throughout and paint the interior of the house with a premium interior paint. The homeowner will select a color. (Do not paint the paneling)
Windows: Remove and replace all windows throughout the home. Install new insulated vinyl, low E, tilt sash windows. Repair any, and all damage due to window replacement, including paint, all trim, including window stools/sills if required, inside and out. Caulk and seal inside and out. Repair or replace any and all deteriorated framing as needed for proper repair. There are approximately 9 singles and 3 double windows in the home. Contractor is responsible for exact window count and measurements.
Finish Carpentry: Replace the existing back steps, build new steps, remove and replace all existing deck boards, and deteriorated joists on the back porch using ground contact treated materials only. Use 2"x6" for deck boards and treads. Remove both bathroom window at shower location, frame as needed and install new smart siding, trim caulk and paint to match exterior paint.
Special Equipment: The Contractor is to provide a storage container large enough to and move all the contents out of the house before working on the inside and back into the house after the job is completed.
Similar Contracts
Same NAICS industry code
More opportunities from Oklahoma → Choctaw Nation Housing Authority
Same awarding agency
Get AI-powered intelligence on this solicitation and the ones like it
Every solicitation package arrives shredded into a compliance breakdown and matched to your past performance, with incumbent history and alerts on amendments and award.
Join 750+ contractors already using CLEATUS
