Replace Complex Roofs - FCC Florence

THIS IS A SOURCES SOUGHT NOTICE. THIS NOTICE IS ISSUED FOR MARKET RESEARCH PURPOSES ONLY. THIS IS NOT A SOLICITATION OR INVITATION FOR OFFERORS TO SUBMIT BIDS. A PRE-SOLICITATION SYNOPSIS OF PROPOSED CONTRACT ACTION WILL BE POSTED AT A LATER DATE THAT WILL PROVIDE INSTRUCTIONS FOR BIDDERS TO RESPOND TO THIS OPPORTUNITY. PLEASE DO NOT RESPOND TO THIS NOTICE IF YOU ARE NOT SERIOUSLY INTERESTED AND IF YOU DO NOT PERFORM THIS REQUIREMENT. IT WILL DELAY THE POSTING OF THE SOLICITATION DUE TO FURTHER MARKET RESEARCH THAT WILL BE REQUIRED. Interested small business contractors are requested to respond to this notice by filling out and emailing completed questionnaire attachment (see attached) to Trisha Holm at contact@example.gov . Responses must be received no later than April 24, 2023. Interested vendors must also add their names to the Interested Vendors List for this posting in https://sam.gov Contract Opportunity (must be logged-in to your account). The Federal Bureau of Prisons (FBOP) anticipates the need for a firm-fixed-price construction contract for a project entitled Replace Complex Roofs, at the Federal Correctional Complex (FCC) Florence, located in Florence, Colorado. FCC Florence is a federally owned facility located at 5880 State Highway 67 South, Florence, CO 81226. The project consists of the following: The Federal Correctional Complex (FCC) Florence Colorado has a requirement for a new roofing system to be installed. The existing roofs at the FPC, FCI, ADX are a fully ballasted EPDM roof that is 27 years old and has exceeded its useful life. The selected contractor is responsible for providing all labor, material, tools, equipment, warranty, and supervision necessary to remove approximately 410,000 sq. ft. of the current roofing system down to, but not including the metal decking and to install a reinforced TPO (Thermoplastic Polyolefin) Fully Secured, TPO membrane must be secured by a nonmechanical method, Roofing System per manufacture specifications. The new roofing system shall include all materials, equipment, and labor needed to complete the roof system such as but not limited to; flashings, insulation, copings, transitions, proper drainage slope, inspection of decking, sealants, glues, primers, substrate materials, penetration seals, fasteners, fiber boards, gypsum boards, termination bars, metals, and vapor protection as specified herein and as indicated on the drawings in accordance with the manufacturer's most current specifications and details. Additional materials shall be installed per manufacture specifications for proper walkways around roof access points, HVAC equipment, security equipment, and roof edges so that the roofing material is protected from punctures, dents, or tears during maintenance and security checks. See additional specifications in section 07 54 00 Thermoplastic Membrane Roofing. The order of the installation for each institution and building shall be determined by the FBOP. The institutional order shall be from the lowest security level to the highest i.e., FPC, FCI, and then the ADX. The building order will be determined by FBOP during the pre-construction meeting. The FBOP reserves the right to change the installation order at any time. Contractor shall remove the existing razor wire as necessary to complete the work on a daily basis. The Contractor shall return all existing razor wire to its permanent location at the end of each working day for security purposes. Contractor shall coordinate all razor wire removal activities with the Contracting Officer Representative (COR) in advance of work. An assembly letter by the manufacture shall be supplied to the Federal Bureau of Prisons (FBOP) that clearly indicates the new roofing system meets a 20-year, 100 mph wind rating, and two-inch hail protection. Refer to individual specification sections for additional warranty requirements. See the Statement of Work/Specifications attachment for the complete requirements for the project. Access to the specifications and drawings attachments will require an active https://sam.gov vendor registration (log in). If you encounter problems accessing these documents, please contact the Federal Service Desk at +1 (555) 000-0000. Interested bidders must be registered in the System for Award Management (SAM) at https://sam.gov. Pursuant to Federal Acquisition Regulation (FAR) 36.204, the estimated magnitude of the project is more than $10,000,000. (NOTE: This range is one of 8 available ranges from FAR 36.204 and is not meant to imply that the project has necessarily been estimated/budgeted to the maximum of the selected range. It merely conveys that the estimate/budget lies somewhere within that range.) The North American Industrial Classification System (NAICS) code applicable to this requirement is 238160 (Roofing Contractors) with a corresponding small business size standard of $19 million. To be considered an interested vendor, you must possess this NAICS code in your https://sam.gov registration. Interested bidders must be registered in https://sam.gov. The FBOP is seeking small business contractors for this project. Your business size metrics information entered in your https://sam.gov registration must be less than or equal to the small business size standard specified above (see provision 52.219-1 in the Representations & Certifications section of your https://sam.gov registration). Interested small business contractors are requested to respond to this notice by filling out and emailing completed questionnaire attachment to Trisha Holm at contact@example.gov. Interested vendors must also add their name to the Interested Vendors List for this posting in https://sam.gov Contract Opportunity (must be logged-in to your vendor account).