Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, October 14 at 2:00 PM EDT

Register Free →

This Government Contract opportunity from North Carolina was posted on August 13, 2026. The submission period has ended. Browse the details below for market research, or find similar active opportunities.

Installation of Pigging Access and Bypass Connections

Closed
State & Local

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

Active Opportunities Like This One

NAICS: 238220
New
Federal
Z1DA--Replace Cast Iron Fittings 676-23-009
Solicitation # 36C25226B0037
Solicitation 36C25226B0037 is a 100 percent set-aside for Service-Disabled Veteran-Owned Small Businesses (SDVOSB) to perform the Replace Cast Iron Fittings project at the Tomah VA Medical Center in Wisconsin. The project involves providing all labor, materials, equipment, and supervision to remove and replace cast iron or malleable/ductile iron fittings and pipe components, including valves and steam traps, within steam generation and distribution systems operating at 15 psig or greater or condensate systems exceeding 257 degrees Fahrenheit. The estimated project magnitude is between 5 million and 10 million dollars, with a performance period of 420 calendar days after the notice to proceed. Award will be granted to the responsible bidder with the lowest responsive base bid. Bidders must provide their current Experience Modification Rate (EMR) and safety records, including OSHA 300 forms for 2023 through 2025, to determine responsibility. As a special trade construction contract, the awarded contractor must certify that they will not pay more than 75 percent of the government paid amount to firms that are not certified SDVOSBs or VOSBs, excluding the cost of materials. Compliance is subject to VA review of records, and failure to act in good faith may result in fines, suspension, debarment, or prosecution. The contract requires a bid bond upon submission, with performance and payment bonds required from the successful bidder. Work must adhere to the Davis-Bacon Act for prevailing wages and the Buy American statute for construction materials. Quality control is mandatory, involving a series of inspections including punch-out, pre-final, and final acceptance inspections conducted by the contractor and the government. All work must comply with federal, state, and local regulations, as well as VA security management programs and specific technical standards such as NFPA 90A and UL 181.
252-NETWORK Contract Office 12 (36C252)

POSTED

about 9 hours ago

DEADLINE

in 9 days
NAICS: 238220
New
Federal
DCDO - HVAC Maintenance
Solicitation # FA527027QB003
The United States Air Force 18th Contracting Squadron is soliciting quotations for a single-award, firm-fixed-price requirements contract to provide HVAC maintenance services for the Defense Communications Detachment Okinawa (DCDO) in Japan. The contract covers a five-year period of performance from December 1, 2026, through November 30, 2031, divided into annual increments. The scope of work includes preventive maintenance inspections, corrective repairs, and the provision of reimbursable parts and materials. Key deliverables include a comprehensive system inventory and a six-month maintenance schedule, both due within 30 days of award, as well as monthly status reports. Under the pricing structure, labor for repairs is included in the periodic maintenance charges, while the contractor is responsible for replacement parts up to 10,000 Yen, with the government reimbursing costs exceeding that amount. Award will be granted to the responsible offeror whose proposal is most advantageous to the government, with price serving as the primary evaluation factor. Offerors must comply with Japanese law regarding insurance and provide specific vehicle documentation for base access. Quotations must be submitted electronically by October 26, 2026, and must include all required FAR representations and certifications, including those related to commercial items and telecommunications equipment.
FA5270 18 Cons Pk

POSTED

about 9 hours ago

DEADLINE

in 18 days

AI Contract Overview

Show more

The Town of Cary in North Carolina is seeking a subcontractor for the installation of pigging access and bypass connections. The primary objective of this project is to install permanent pigging access points and temporary bypass piping, which will facilitate smart pig inspections while ensuring that system operations remain uninterrupted. This subcontract opportunity is categorized under NAICS code 238220. Interested parties must submit their responses by the deadline of August 27, 2026, following the posting date of August 13, 2026.

General Info

Town of Cary seeks subcontractor for pigging access and bypass installation by August 2026.

Documents

This scope was carved out of SW-03550-01.

The full solicitation package (1 document), including the RFP, is on the prime solicitation, not on this scope.

View the prime solicitation

Force Main Inspection & Maintenance (Re-bid)

AI Contract Breakdown

Uniform Contract Format

No documents to break down

The breakdown needs solicitation documents. None were found from this contract's source.

Timeline

PhaseClosed
Posted

subcontract

Response Deadline

Deadline has passed

Submission Closed

Find active opportunities like this

Start your free trial to discover similar active contracts, track opportunities, and build proposals with AI assistance.

Organization & Contact Information

Show more
AgencyNorth Carolina → Town of Cary
ContactsNo contacts available
OfficeN/A
Organization / AgencyNorth Carolina → Town of Cary
Office AddressN/A
ContactsNo contact information available

Full Description

Show more
Install permanent pigging access points and temporary bypass piping to enable smart pig inspection while maintaining system operation.

More opportunities from North Carolina → Town of Cary

Same awarding agency

NAICS: 237310
New
SLED
W Johnson St & Nottingham Dr Sidewalk Projects
Solicitation # 354-TR27-15
The Town of Cary is soliciting sealed bids for the W Johnson St & Nottingham Dr Sidewalk Project (Project No. ST1264), which involves providing all materials, labor, and equipment for sidewalk construction in Cary, North Carolina. The scope of work includes approximately 1,700 linear feet of sidewalk on Nottingham Dr, featuring curb ramps, two bus stops, signage, pavement marking, and utility adjustments. Additionally, the project requires approximately 600 linear feet of sidewalk on W Johnson St, including curb ramps, curb and gutter work, slope fill, LED signage, utility adjustments, and a bus stop upgrade. The contract will be awarded to the lowest responsive and responsible bidder who is licensed to perform the specified contracting in the State of North Carolina. Bids must be submitted in sealed envelopes to the Town of Cary front desk lobby by 1:30 PM ET on October 29, 2026, following a non-mandatory pre-bid meeting on October 13, 2026. Required submission documents include a bid bond or deposit of at least five percent of the bid amount, a non-collusive affidavit, and verification of work authorization. Because the project is funded by Federal Transit Authority (FTA) Locally Administered Projects Program (LAPP) funds, bidders must provide certifications for Davis-Bacon compliance, Buy America and Build America, lobbying, and the unavailability of US-Flag air carriers. Performance and payment bonds of up to 100 percent of the contract amount are required, with payment due within thirty days after final acceptance.
Highway, Street, and Bridge Construction

POSTED

7 days ago

DEADLINE

in 22 days
View Details
NAICS: 541330
SLED
Request for Qualifications - Master Plan & Rerating Analysis for North Cary Water Reclamation Facility (NCWRF)
Solicitation # 354-UT27-12
The Town of Cary Utilities Department is soliciting qualifications for one or more firms to develop a comprehensive 25-year master plan for the expansion of the North Cary Water Reclamation Facility. The primary objective of this project is to strategically utilize existing infrastructure to accommodate future growth, specifically through a re-rating analysis to increase the facility's capacity from 12.0 to 15.0 million gallons per day. Additionally, the selected firm will evaluate alternatives for expanding the grit and grease removal facility. The facility currently employs the Veolia-Kruger BioDenpho Phased Isolation Ditch process for Biological Nutrient Removal. This solicitation, RFQ 354-UT27-12, is issued under the Mini-Brooks Act, meaning selection is based on qualifications and price will not be a determining factor in the award. Interested firms must submit a proposal of no more than 40 PDF pages via the North Carolina electronic Vendor Portal by November 18, 2026, at 3:00 PM ET, with questions due by October 28, 2026. Submissions must include a cover letter, corporate background, and an organizational chart identifying a dedicated Project Manager and key personnel. While price is not a selection factor, firms are required to provide an hourly rate schedule as a separate file. The Town will rank the most qualified firms and begin contract negotiations with the top-ranked respondent.
Engineering Services

POSTED

8 days ago

DEADLINE

in about 1 month
View Details
NAICS: 423830
SLED
Cake Feed Pump Parts & Dosing Pump Parts
Solicitation # 354-RFB-27-13
The Town of Cary is soliciting bids for the purchase and delivery of cake feed pump parts and dosing pump parts, including associated equipment, for the Western Wake Regional Water Reclamation Facility in New Hill, North Carolina. This fixed-price contract is for an initial term of six months, with the option to extend for five additional six-month periods. The solicitation, numbered 354-RFB-27-13, requires bidders to be authorized dealers and to provide materials that match specific Netzsch part numbers. Bids must be submitted electronically via the North Carolina electronic Vendor Portal by 4:00 PM on October 14, 2026, with questions due by October 7, 2026. The contract will be awarded to the lowest responsive and responsible bidder. Key requirements include providing a one-year warranty from the date of delivery and adhering to FOB destination shipping terms, with all freight and handling costs included in the quote. Deliveries must occur between 9:00 AM and 3:00 PM on weekdays. The selected supplier must maintain comprehensive insurance coverage, including commercial general liability, automobile, and workers compensation. Payment terms are Net 30 days following the receipt of a correct invoice or acceptance of goods. All equipment must comply with applicable federal, state, and local safety regulations, including OSHA and EPA standards.
Industrial Machinery and Equipment Merchant Wholesalers

POSTED

8 days ago

DEADLINE

in 7 days
View Details

Find Active Opportunities Like This

Get AI-powered intelligence on the opportunities still open

Every page of the solicitation package shredded into a compliance breakdown

AI-powered matching based on your capabilities and past performance

Competitor and incumbent history on the requirement

Automated alerts on amendments, Q&A deadlines, and award

Miguel
Hillary
Keith Deutsch
Christine

Join 750+ contractors already using CLEATUS