PIN, DRIVE, GUIDED

The contract involves the procurement of a single unit of a pin, drive, guided component identified by NSN 5315016848712 and part number 941089-1, to be manufactured in strict accordance with drawing 1X4F3 AMSCBDOC, revision dated 03/07/2007. The item is source-controlled and must be produced and tested using limited rights data accessible only to qualified vendors with traceability to approved sources; no government-provided data is available, and a SAR package is required for source approval consideration. Delivery is required within ten days of award, FOB origin, to the US Army SSA Bulgaria at Novo Selo Training Area, Building 7000, Mokren 8994, Bulgaria, with no variance allowed in quantity. Packaging must comply with MIL-STD-2073-1E, with specific parameters for preservation, unit containment (BL), intermediate containers (ED, qty 100), and packaging code (U), while marking must follow MIL-STD-129 with no special marking required. Palletization must adhere to DLA packaging requirements. Inspection and acceptance occur at destination using destination inspection protocols under FAR 52.246-2. Sampling shall be conducted using MIL-STD-1916, ASQ H1331 Table 1, or an equivalent zero-based system, with critical, major, and minor attributes assigned verification levels VII, IV, and II or AQLs of 0.1, 1.0, and 4.0 respectively; unspecified attributes are considered major. Zero non-conformances are required for acceptance unless otherwise stated, and manufacturers may choose between attribute or variable inspection under MIL-STD-1916. Technical data must be retrieved from the DLA portal, and discrepancies must be reported through the DLA customer service site. The contract is a simplified acquisition under DLA Master Solicitation Revision 105, with mandatory compliance with FAR and DFARS clauses including whistleblower protections, disclosure of information, cyber incident reporting limits, safety issue notifications, transportation by sea, and prohibitions on internal confidentiality agreements. Contractors must maintain active SAM registration, submit required small business and exclusions representations, and comply with hazardous materials labeling under DFARS 252.223-7001 and 29 CFR 1910.1