RACEWAY, NONMETALLIC

The contract solicitation SPE4A7-26-T-544F seeks the procurement of 100 lengths of nonmetallic raceway, identified by NSN 5975-01-431-3657 and reference part number PANDUIT CORP. LD51W6-A, with each length defined as six feet. The item is subject to stringent quality and technical requirements outlined in the DLA Master List of Technical and Quality Requirements, and manufacturers must comply with tailored higher-level contract quality standards as well as the requirement to remove government identification from non-accepted supplies. Sampling and acceptance must follow MIL-STD-1916, ASQ H1331 Table 1, or a comparable zero-based sampling plan, with critical, major, and minor attributes assigned verification levels of VII, IV, and II or AQLs of 0.1, 1.0, and 4.0 respectively; unspecified attributes are treated as major. Zero non-conformances are required if MIL-STD-105/ASQ Z1.4 is used for sample sizing. The manufacturer’s inspection system must comply with ISO 9001:2015 or an equivalent standard. Packaging and marking must adhere to MIL-STD-2073-1E and MIL-STD-129, with specific packaging codes and preservation methods detailed, and all hazardous materials must be labeled in accordance with 29 CFR 1910.1200. Delivery is required within 20 days ADO under FOB destination terms, and vendors must use the Wide Area WorkFlow system to submit invoices and receiving reports. The contract incorporates comprehensive cybersecurity requirements including DFARS 252.204-7012 for safeguarding covered defense information and cyber incident reporting, and applies NIST SP 800-171 and the Buy American Act with a reduced Berry Amendment threshold of $150,000. Offerors must be registered in SAM, provide accurate socioeconomic status representations including small business, HUBZone, and WOSB status, disclose use of non-domestic materials, and confirm no provision of covered defense telecommunications equipment under DFARS 252.204-7018. The solicitation is a small business set-aside and may be awarded automatically, with preference given to HUBZone concerns. All submissions must be made via