Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, September 16 at 2:00 PM EDT

Register Free →

Rail Grout Demolition and Installation

Active
Federal

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

General Info

Agency

Department Of Defense → W071 Endist OmahaView Agency

NAICS

238110 - Poured Concrete Foundation and Structure ContractorsView NAICS

Place of Performance

NE, 68730

Set-Aside

NONE

Documents

This scope was carved out of W9128F26RA023.

The full solicitation package (5 documents), including the RFP, is on the prime solicitation, not on this scope.

View the prime solicitation

Gavins Point Crane Rail Replacement

AI Contract Breakdown

Uniform Contract Format

No contract breakdown available.

Cannot generate Contract Breakdown because no documents were found from this contract's source.

Timeline

Posted

subcontract

Response Deadline

Submission deadline

Response Deadline

Ready to pursue this opportunity?

Start your free trial to track this contract, build proposals with AI assistance, and manage your pipeline.

Organization & Contact Information

Show more
AgencyDepartment Of Defense → W071 Endist Omaha
ContactsNo contacts available
OfficeN/A
Organization / Agency
Department Of Defense → W071 Endist Omaha
View Agency Profile
Office AddressN/A
ContactsNo contact information available

Full Description

Show more
Performs rail grout demolition and installation for prime contractors on USACE projects at Gavins Point Dam. Demolishes existing rail grout, removes damaged monolith joint seals, and places, finishes, and cures structural concrete/rail chase grout to prevent shrinkage cracking. Slopes grout for water drainage and installs new monolith joint seals. Delivers demolished existing grout and newly installed, cured, and tested grouted bearing surfaces.

Similar Contracts

Same NAICS industry code

NAICS: 238110
New
Sidewalk Repair at Little Rock Job Corps Center
Solicitation # sidewalk-repair-little-rock-job-corps-center
This subcontracting opportunity, issued by Serrato Corporation for the Little Rock Job Corps Center in Arkansas, requires a contractor to perform sidewalk repairs specifically at the Building 0006 Women’s Dorm. The scope of work focuses on mitigating trip hazards and ensuring safety compliance by grinding elevated sidewalk areas level at the front vestibule and Willow Wing exit, infilling a 6 by 6 inch hole with 3000 psi concrete near the Magnolia Wing, and installing yellow safety warning strips at the west end of the Magnolia and Willow Wings in accordance with NFPA 101 standards. The project is sales and use tax exempt and is governed by the Federal Acquisition Regulation, with a requirement that the contractor restore the work area to its original documented condition upon completion. The award will be based on the most advantageous proposal considering price and price-related factors. To be eligible, offerors must provide a detailed fixed-price quote, a sequenced project schedule, proof of a valid Arkansas State Contractor's License, and evidence of at least five years of relevant experience. Additional requirements include SAM eligibility, a 90-day bid guarantee, and compliance with Davis-Bacon/Service Contract Act prevailing wage rates via form SF-1413. Work is expected to commence within five business days of the award, and the contractor must provide a certificate of insurance naming Serrato Corporation. This opportunity is set aside for Small Businesses, including SDB and WOSB certifications.
Little Rock Job Corps 6900 Scott Hamilton Drive Little Rock AR 72019

POSTED

about 11 hours ago

DEADLINE

in 10 days
View Details

More opportunities from Department Of Defense → W071 Endist Omaha

Same awarding agency

NAICS: 238120
New
Federal
Gavins Point Crane Rail Replacement
Solicitation # W9128F26RA023
The U.S. Army Corps of Engineers, Omaha District, is soliciting bids for the Gavins Point Intake Crane Rail Replacement project located in Crofton, Nebraska. This unrestricted solicitation, open to both large and small businesses under NAICS code 238120, involves the removal and replacement of the 80-ton powerhouse intake gantry crane runway rail. The scope of work includes an initial alignment survey, demolition of existing rails, clips, and anchors, and the installation of new rails aligned to CMAA 70 standards. A key requirement is the replacement of approximately 80 percent of existing anchors and all joint bar anchors with hardware suitable for cracked concrete and seismic loading, followed by filling grout pockets with two-component aliphatic polyurethane elastomer grout. The project is estimated to cost between 1,000,000 and 5,000,000 dollars, with a performance period of 365 calendar days from the Notice to Proceed. Contractors must follow a specific sequencing plan to minimize crane downtime, typically progressing from one side of the dam to the other. The solicitation closes on October 2, 2026, and includes a site visit scheduled for September 3, 2026. Amendment 0001 has updated the submission requirements to include a Small Business Participation Proposal Worksheet. Proposals will be evaluated based on a best-value unrestricted RFP process, with firm-fixed-price line items for mobilization, demolition, and installation.
Structural Steel and Precast Concrete Contractors

POSTED

1 day ago

DEADLINE

in 29 days
View Details
NAICS: 335312
New
Federal
60kW Stationary Standby Generator Set - Chatfield Dam, Colorado
Solicitation # W9128F26QA094
Solicitation W9128F26QA094 is a request for quote for the purchase, delivery, and startup of one 60kW stationary standby diesel generator set for the Tri-Lakes Project at Chatfield Dam in Littleton, Colorado. The required equipment must be a Generac Industrial Power Model SD060 or an approved equivalent, featuring a 60kW/75kVA rated capacity, 277/480V 3-phase 60 Hz system, and a 100A 3-pole circuit breaker. The unit must be an open-skid, tank-less configuration with a weather-protective enclosure, a 120V AC jacket water heater, and an NFPA 110 compliant battery charger. The contractor is responsible for all shipping and handling costs, with delivery required FOB destination within twenty weeks of the contract award. This is a total small business set-aside procurement utilizing Lowest Price Technically Acceptable (LPTA) basis for award. To be considered technically acceptable, offerors must provide manufacturer cut sheets and meet all physical and performance specifications. Past performance is evaluated as a pass/fail gate, requiring up to three references from the last three years. Final acceptance is contingent upon the successful delivery of new, functional equipment and the provision of all operating and service manuals. The scope also includes comprehensive startup services, including pre-start, start-up, and load testing inspections, as well as handover documentation and owner training. Payments will be made by check within 30 days of receipt of a completed invoice.
Motor and Generator Manufacturing

POSTED

3 days ago

DEADLINE

in 12 days
View Details