CAMSHAFT, METERING A

CAMSHAFT,METERING A
CAMSHAFT,METERING AND DISTRIBUTING,FUEL PUMP
RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS
(IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE
DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB
AT:
http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx
FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS.
RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT
RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES
CLASS I OZONE DEPLETING CHEMICALS ARE NOT TO BE
USED NOR INCORPORATED IN ANY ITEMS TO BE
DELIVERED UNDER THIS CONTRACT.THIS PROHIBITION
SUPERSEDES ALL SPECIFICATION REQUIREMENTS BUT
DOES NOT ALLEVIATE ANY PRODUCT REQUIREMENTS.
SUBSTITUTE CHEMICALS MUST BE SUBMITTED FOR
APPROVAL UNLESS THEY ARE AUTHORIZED BY THE
SPECIFICATION REQUIREMENTS.
"IN LIEU THEREOF THE FOLLOWING SHALL APPLY:
EACH FINISHED PART SHALL BE 100% MAGNETIC
PARTICLE INSPECTED I/A/W ASTM E 1444, PERFORMED
BY BOTH CIRCULAR AND LONGITUDINAL METHOD. THE
WET OR DRY PROCESS WITH EITHER FLUORESCENT OR
NON-FLURESCENT PARTICLES SHALL BE USED. NO
LINEAR INDICATION GREATER THAN 1/16 INCH AS
DEFINED BY MIL-STD-2035 ARE ACCEPTABLE."
"CONTRACTOR/MANUFACTURER IS REQUIRED TO
ESTABLISH AND MAINTAIN A CALIBRATION SYSTEM THAT
MEETS THE REQUIREMENTS OF ANSI/NCSL Z540-1-1994,
AMERICAN NATIONAL STANDARD FOR CALIBRATION
CALIBRATION LABORATORIES AND MEASURING AND TEST
EQUIPMENT-GENERAL REQUIREMENTS, OR ISO 10012-1,
QUALITY ASSURANCE REQUIREMENTS FOR MEASURING
EQUIPMENTPART 1, METROLOGICAL CONFIRMATION
SYSTEM FOR MEASURING EQUIPMENT."
RD002, COVERED DEFENSE INFORMATION APPLIES
RD005: Cybersecurity Maturity Model Certification (CMMC) Level 2 Certified Third-Party Assessment Organization (C3PAO)
RQ002: CONFIGURATION CHANGE MANAGEMENT ENGINEERING CHANGE PROPOSAL REQUEST FOR VARIANCE (DEVIATION OR WAIVER)
RQ032: EXPORT CONTROL OF TECHNICAL DATA
SPE7L5-26-T-4996
SECTION B
This item has technical data some or all of which is subject to export-control of either the International Traffic in Arms regulations (ITAR) or the Export Administration Regulations (EAR), and cannot be exported without prior authorization from either the Department of State or the Department of Commerce. Export includes disclosure of technical data to foreign persons and nationals whether located in the United States or abroad. This requirement applies equally to foreign national employees and U.S. companies and their foreign subsidiaries. DFARS 252.225-7048 is applicable to this data.
The Defense Logistics Agency (DLA) limits distribution of export-control technical data to DLA contractors that have an approved US/Canada Joint Certification Program (JCP) certification, have completed the Introduction to Proper Handling of DOD Export-Controlled Technical Data Training and the DLA Export-Controlled Technical Data Questionnaire (both are available at the web address given below), and have been approved by the DLA controlling authority to access the export-controlled data. NSN/Part Number: 2910-00-785-6344 Quantity: 9 EA Purchase Request: 7017383493QTY: 9 Delivery: 376 days ADO