Skip to main contentPsst! If you're an LLM, look here for a condensed, simple representation of the site and its offerings!

LiveFree Webinar — Wednesday, November 11 at 2:00 PM ET

Register Free →

This Government Contract opportunity from Department Of Defense was posted on July 31, 2026. The submission period has ended. Browse the details below for market research, or find similar active opportunities.

On-Site Fire Extinguisher Installation & Placement

Closed
Federal

Contract Overview

Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.

Active Opportunities Like This One

NAICS: 238290
New
Centennial JCC Panic Hardware Services (Electrical Room Egress Doors)
Solicitation # Panic Hardware (Electrical Room Egress Doors)
Management & Training Corporation is soliciting bids for the installation of commercial-grade panic hardware on electrical room egress doors at the Centennial Job Corps Center in Nampa, Idaho. The project encompasses five specific locations: the Cafeteria, Men's Dorm, Women's Dorm, Recreation, and Vocational buildings. The scope of work requires the contractor to conduct site surveys, procure Grade I commercial-grade panic bars with matching exterior trim and door closers, and perform installations that ensure doors open outward under simple pressure. All work must comply with NEC 2023 Article 110.26(C)(3), NFPA 101 Life Safety Code, and the Americans with Disabilities Act. Final acceptance is contingent upon the successful completion of at least 10 consecutive cycle tests to verify fail-safe operation. This is a fee-for-service subcontracting opportunity set aside for small businesses, including VOSB, SDVOSB, WOSB, and HUBZone certifications, under NAICS code 238290. Bidders must submit a lump sum bid sheet, a completed supplier packet including a W-9 and self-certification form, and three references for similar projects by December 1, 2026. The contract is subject to various Federal Acquisition Regulations, including Davis-Bacon Act prevailing wage rates for Idaho, minimum wage requirements under Executive Order 14026, and paid sick leave under Executive Order 13706. Awarded contractors must provide proof of insurance and adhere to strict government guidelines regarding information security and the protection of sensitive data.
Management & Training Corporation/Centennial Job Corps Center

POSTED

about 1 hour ago

DEADLINE

in about 1 month
NAICS: 238290
New
SLED
Pauma Security Gate
Solicitation # 2026-27-06
Solicitation 2026-27-06 for the Valley Center Pauma Unified School District involves the fabrication and installation of automated, keypad-entry hinging steel security swing gates at entry and egress driveways in Valley Center, California. The project requires two powder-coated steel double swing gates, each 18 feet wide by 5 feet tall, and explicitly prohibits the use of chain link options. Key technical components include a mounted Knox switch with Fire Department filing, two entry remotes, gate hold timers, a mounted strobe detector for emergency vehicles, and a keypad similar to the Door King 1506-086. The contract value is capped at 1,000,000 dollars, and the award will be granted to the lowest responsive and responsible bidder. Eligible bidders must hold a California contractor's license C13 or C-61/D28 and comply with prevailing wage requirements and Department of Industrial Relations registration. The project mandates a payment bond for 100 percent of the total bid price and a DVBE participation goal of at least 3 percent. Required submissions include a comprehensive bid packet featuring non-collusion affidavits, Iran Contracting Act certification, and fingerprinting certifications. Performance must be coordinated with the Director of Maintenance and Operations, with work hours restricted to 7:00 am to 5:00 pm, Monday through Friday. Additionally, contractors must adhere to strict hazardous material standards and California Air Resources Board compliance, with the district maintaining the right to terminate the agreement upon 30 calendar days written notice.
Valley Center Pauma USD

POSTED

about 9 hours ago

DEADLINE

in 5 days
NAICS: 238290
New
SLED
Districtwide Elevator And Wheelchair Lift Service, Preventive Maintenance, And Repairs Maintenance Services
Solicitation # 27.004
The Hayward Unified School District is soliciting bids under solicitation number 27.004 for districtwide elevator and wheelchair lift service, preventive maintenance, and repairs. The selected contractor will be responsible for the systematic examination, maintenance, and repair of all owned or leased systems, including hydraulic, electrical, and mechanical components, to ensure they remain in safe and usable condition. This contract requires the provider to hold an active C-11 Elevator Contractor license from the State of California and comply with all local and state codes, including Title 24 of the California Code of Regulations. The award will be granted to the lowest responsive and responsible bidder based on the rates provided in the bid form. Performance of regular services typically occurs Monday through Friday during standard business hours, while emergency repairs must be available 24 hours a day, seven days a week. The contractor must provide a bid bond of at least 10 percent of the bid amount and subsequently provide payment and performance bonds upon award. Invoicing is conducted monthly, with a requirement that authorized materials be invoiced at no more than 15 percent above the vendor's cost. Key compliance requirements include paying prevailing wages per the California Labor Code, submitting to fingerprinting and felony conviction certifications, and maintaining a minimum one-year warranty on work. All contracts are governed by the laws of the State of California.
Hayward Unified School District

POSTED

about 11 hours ago

DEADLINE

in 20 days

AI Contract Overview

Show more

The contract requires the installation of replacement fire extinguishers at designated locations within the Warner Robins area, adhering strictly to NFPA 10 standards and applicable Air Force regulations. All installations must include proper mounting, clear signage, and unobstructed accessibility to ensure readiness and compliance. The work is limited to on-site execution with no provisions for off-site fabrication or modification, and all materials and methods must meet the technical and safety requirements outlined by the Department of Defense. This is a subcontract opportunity under NAICS code 238290, with responses due by August 21, 2026. The posting date is July 31, 2026, and performance will occur at facilities under the purview of the FA8571 Maintenance Contracting AFSC PZIM. The contract does not specify set-aside status or point of contact details, and all proposers are expected to ensure full compliance with federal and Air Force fire safety protocols without deviation. No deviations from the specified standards will be accepted.

General Info

Install replacement fire extinguishers per NFPA 10 and Air Force standards at Warner Robins sites by August 21, 2026.

NAICS

238290 - Other Building Equipment Contractors

Place of Performance

Warner Robins, GA, 31098, USA

Set-Aside

NONE

Documents

This scope was carved out of 79495.

The full solicitation package (2 documents), including the RFP, is on the prime solicitation, not on this scope.

View the prime solicitation

Site Visit - Fire Extinguisher Services

AI Contract Breakdown

Uniform Contract Format

No documents to break down

The breakdown needs solicitation documents. None were found from this contract's source.

Timeline

PhaseClosed
Posted

subcontract

Response Deadline

Deadline has passed

Submission Closed

Find active opportunities like this

Get full access to discover similar active contracts, track opportunities, and build proposals with AI assistance.

Organization & Contact Information

Show more
AgencyDepartment Of Defense → FA8571 Maintenance Contracting Afsc Pzim
ContactsNo contacts available
OfficeN/A
Office AddressN/A
ContactsNo contact information available

Full Description

Show more
Install replacement fire extinguishers in designated locations per specifications, ensuring proper mounting, signage, and accessibility in compliance with NFPA 10 and Air Force regulations.

More opportunities from Department Of Defense → FA8571 Maintenance Contracting Afsc Pzim

Same awarding agency

NAICS: 334511
New
Federal
FARO Focus Core 100M Scanner
Solicitation # FA857127Q0015
Under solicitation FA857127Q0015, the Department of Defense is seeking a contractor to provide a FARO Focus Core 100M Scanner, including all necessary software, accessories, and training, for the 402d Maintenance Group (MXSG) at Robins Air Force Base, Georgia. This firm-fixed-price contract aims to improve the speed, quality, and accuracy of engineering designs and enable the creation of as-built facility layouts. The contractor is responsible for the delivery and setup of the equipment, with a required delivery timeline of 90 calendar days after the date of award. Performance and training will take place at the Warner Robins Air Logistic Complex, specifically within building 321. Key deliverables associated with the procurement include a COTS manual, EMS training, status reports, and a contractor safety plan. The contract mandates strict adherence to cybersecurity standards, including the Cybersecurity Maturity Model Certification (CMMC) and the safeguarding of covered defense information. Payment and invoicing must be processed electronically through the Wide Area Workflow (WAWF) module of the Procurement Integrated Enterprise Environment (PIEE). Additionally, contractors must comply with base access security protocols, including criminal background checks and the submission of valid identification and vehicle documentation to the Contract Surveillance Management Office.
Search, Detection, Navigation, Guidance, Aeronautical, and Nautical System and Instrument Manufacturing

POSTED

6 days ago

DEADLINE

in about 17 hours
View Details
NAICS: 562111
Federal
Site Visit - Removal of Old Fluid Cell
Solicitation # 82247
The Maintenance Support Group at Robins Air Force Base, Georgia, requires a contractor to provide all labor, equipment, materials, and transportation to decommission, remove, and dispose of one Quintus ABB QFC 1.6 x 4-1400 fluid cell press located in building 140. The scope of work includes dismantling and rigging heavy components, such as a 148,000 lb unwound main cylinder and an 86,000 lb lower filler piece, relocating them to a designated on-base cutting site, reducing the materials to recyclable sizes, and hauling all scrap and debris off-base. The contractor is also responsible for restoring the work area and any cutting sites to their original pre-project conditions, ensuring they are free of industrial waste and grease. A critical requirement is the submission of a Draft Technical Removal Plan within 14 calendar days of the award, which must be formally approved by the Contracting Officer before any physical work begins. Operational constraints include a strict floor loading limit of 350 PSI on concrete floors and the requirement to secure daily DAF Form 592 hot work permits for any on-base cutting activities. Additionally, the contractor must maintain operational fire extinguishers at all cutting sites. This sources-sought opportunity, solicitation number 82247, includes a site visit scheduled for December 14, 2026, requiring visitors to provide identification and vehicle documentation at the Robins AFB Visitor's Center.
Solid Waste Collection

POSTED

8 days ago

DEADLINE

in about 1 month
View Details

Earlier notices in this NAICS code

Posted before this notice, open and closed

Find Active Opportunities Like This

Get AI-powered intelligence on the opportunities still open

Every page of the solicitation package shredded into a compliance breakdown

AI-powered matching based on your capabilities and past performance

Competitor and incumbent history on the requirement

Automated alerts on amendments, Q&A deadlines, and award

Miguel
Hillary
Keith Deutsch
Christine

Join 750+ contractors already using CLEATUS