NSN U-132 INSTALL FENCE AROUND COOLING TOWER
Active
FederalContract Overview
Solicitation details, issuing organization, response deadlines, documents, and interested companies for this government contract opportunity.
General Info
Agency
Department Of The Navy → Navfac Mid-AtlanticView Agency
NAICS
N/A
Place of Performance
ML: NORFOLK, USASet-Aside
8A
Documents
(0)AI Contract Breakdown
Uniform Contract FormatNo contract breakdown available.
Cannot generate Contract Breakdown because no documents were found from this contract's source.
Timeline
Organization & Contact Information
Show more
AgencyDepartment Of The Navy → Navfac Mid-Atlantic
ContactsNo contacts available
OfficeN/A
Office AddressN/A
ContactsNo contact information available
Full Description
Show more
The construction of 225 linear feet of fence is to protect a single point of failure where utility (water) entering the building to allow full capability of A/C supplying the building. In addition, it is a physical security requirement for SCIF building and it was a finding during the MAA inspection. Special Requirements: - Fencing fabric must be minimum 9-gage wire mesh and mesh openings must not be greater than 2-inches (51 mm) per side. - Fence fabric will be galvanized steel. - The fencing fabric must be extended to within 2 inches (51 mm) of firm ground and anchored using horizontal bottom rails prevent the fencing fabric from being able to be lifted by hand more than 5 inches (125 mm) in height. - Locate all posts, rails, bracing and tension wires on the secure/protected side, i.e. inner side, of the fencing fabric. - Twisted selvage must be provided on the top of the fence fabric to deter climbing. - Selvage may be knuckled AS the fence will have a bottom rail. - Fencing fabric will be mounted on steel posts that are set in concrete with additional bracing at corners and gate openings. - Posts must be vertical within plus or minus 2 degrees in each direction. - Posts for security fencing must be embedded and encased in concrete. - Steel truss rods used for bracing must have a minimum nominal diameter of 5/16 inch (8 mm) and provided with turnbuckles for tensioning. - Bracing will be provided for each gate, terminal and end post. - Truss rods will be installed diagonally from near ground level of the gate, t ... NOTE: description has been truncated, please see Project Note for full description.
More opportunities from Department Of The Navy → Navfac Mid-Atlantic
Same awarding agency
